Abstract:3D wafer or chip stacking by through-silicon vias (TSVs) has brought the industry close to a breakthrough. For fabricating TSV structure, a serious challenge is the front side chemical mechanical planarization (CMP) process and especially non-uniformity within 300 mm post-CMP wafers. This paper makes thorough investigation into front side CMP by studying material removal rate (MRR) selectivity and non-uniformity (NU) in TSV and corresponding copper/TEOS layer removal. MRR and NU of different layers were measured under different polishing down force and hydrogen peroxide concentration, and removal rate selectivity was calculated and compared. The results showed that down force should be controlled to achieve a high material removal rate while greatly maintaining NU in a low level. Hydrogen peroxide concentration had a very strong influence on MRR and selectivity of copper/TEOS oxide and directly leads to via dishing situation, which influence the non-uniformity. Subsequently, an ideal combination of process parameters were achieved to obtain a good result in terms of low non-uniformity. This was applied to TSV polishing to verify performance and stability, conducted in a marathon test including TSV/copper/TEOS wafers. In order to facilitate the explanation of TSV removal, the synergistic effect of different layers and removal mechanism on TSV CMP were explained. This conform to the experiments, which is of great value to further research about profile control in the TSV CMP process.

Research on Improvement of CMP Thickness Uniformity Control on Wafer Edge Defocus Defects

Research on CMP Process Parameters Effect on Slurry Transport

Alignment Methods for Micron-Scale Surface Defects Automatic Evaluation of Large-Aperture Fine Optics

The Inspection and Solution of Inline CT Defect for 28NM Process Improvement

Wafer Back Pressure Control and Optimization in the Cmp Process

Defect Law of Cu/Co Patterned Wafers After Using a Novel Bulk/Barrier Slurry and Cleaning Solution

Study of the Formation of Copper Void Defect and Process Optimization For Reduction In Dual Damascene Process

Edge Effects of an Eddy-Current Thickness Sensor During Chemical Mechanical Polishing

A Comprehensive study of reliability improvement for 65nm Cu/Low-k process

Improvement of Via Dishing and Non-Uniformity in TSV Chemical Mechanical Planarization

Analysis of Linewidth Uniformity and Line Edge/Width Roughness in a 5 Nm Logic SAQP Process

TSV CMP process optimization and dishing defect reduction

(Digital Presentation) Uniformity and Profile Improvement of Fin Etching Process at Wafer Extreme Edge for Finfet Mass Production

Numerical and Experimental Investigation on Multi-Zone Chemical Mechanical Planarization

Investigation of the Behaviors of Various Electroplated Copper Films During CMP

Non-uniformity and Removal Rate Selectivity Investigations in Through Silicon Via Front Side CMP

Analysis on Pad Effects in Chemical Mechanical Polishing

Behavior of Copper Removal by CMP and Its Correlation to Deposit Structure and Impurity Content

Wafer Edge Process Integration and Defect Inspection with the Immersion Lithography Process

Experimental and numerical analysis of wafer-to-wafer uniformity in double-sided polishing

In-situ measurement of Cu film thickness during the CMP process by using eddy current method alone