Abstract:With the advancement of high-integration and high-density interconnection in chip manufacturing and packaging, Cu bumping technology in wafer- and panel- level packaging is developed to micrometer-sized structures and pitches to accommodate increased I/O numbers on high-end integrated circuits. Driven by this industrial demand, significant efforts have been dedicated to Cu electroplating techniques for improved pillar shape control and solder joint reliability, which substantially depend on additive formulations and electroplating parameters that regulate the growth morphology, crystal structure, and impurity incorporation in the process of electrodeposition. It is necessary to investigate the effect of an additive on Cu pillar electrodeposition, and to explore the Kirkendall voids formed during the reflowing process, which may result from the additive-induced impurity in the electrodeposited Cu pillars. In this work, a self-synthesized polyquaterntum (PQ) was made out with dual suppressor and leveler effects, and was combined with prototypical accelerator bis- (sodium sulfopropyl)-disulfide (SPS) for patterned Cu pillar electroplating. Then, Sn96.5/Ag3.0/Cu0.5 (SAC305) solder paste were screen printed on electroplated Cu pillars and undergo reflow soldering. Kirkendall voids formed at the joint interfaces were observed and quantified by SEM. Finally, XRD, and EBSD were employed to characterize the microstructure under varying conditions. The results indicate that PQ exhibits significant suppressive and levelled properties with the new structure of both leveler and suppressor. However, its effectiveness is dependent on liquid convection. PQ and SPS work synergistically, influencing the polarization effect in various convective environments. Consequently, uneven adsorption occurs on the surface of the Cu pillars, which results in more Kirkendall voids at the corners than at the center along the Cu pillar surface.

Study of the Formation of Copper Void Defect and Process Optimization For Reduction In Dual Damascene Process

Defectivity Characterization of post-CMP Voiding in 32nm Cu Metallization

Improved Electrochemical Plating for Void-Free Copper Line in ULSI Interconnect

A New Copper Electrodeposition Scheme to Reduce Void Defects after Chemical Mechanical Polishing

Void Defect Reduction after Chemical Mechanical Planarization of Trenches Filled by Direct/Pulse Plating

Mechanism for Cu Void Defect on Various Electroplated Film Conditions

A Comprehensive study of reliability improvement for 65nm Cu/Low-k process

A Low Cost and Residue-Free Abrasive-Free Copper Cmp Process with Low Dishing, Erosion and Oxide Loss

Comparison of the Time-Dependent Physical Processes in the Electromigration of Deep Submicron Copper and Aluminum Interconnects

Investigation of the Behaviors of Various Electroplated Copper Films During CMP

Top Metal Layer Electro Plating Edge Bevel Removal Improvement Study

Understanding the Impact of Surface Engineering, Structure, and Design on Electromigration Through Monte Carlo Simulation and In‐Situ SEM Studies

Voidless metal filling and elimination of metal diffusion in PVD barrier and seed process for high performance Cu interconnect

Research on Improvement of CMP Thickness Uniformity Control on Wafer Edge Defocus Defects

Study Charge Effect in Dual Damascenes Etch Process of 0.13 μm Cu-line Technology

Metal hard-mask based AIO etch challenges and solutions

Electromigration-induced void evolution and failure of Cu/SiCN hybrid bonds

Defect Law of Cu/Co Patterned Wafers After Using a Novel Bulk/Barrier Slurry and Cleaning Solution

Cu Pillar Electroplating Using a Synthetic Polyquaterntum Leveler and Its Coupling Effect on SAC305/Cu Solder Joint Voiding

FEA study on the TSV copper filling influenced by the additives and electroplating process

Behavior of Copper Removal by CMP and Its Correlation to Deposit Structure and Impurity Content