Abstract:Laser debonding technology has been widely used in advanced chip packaging, such as fan-out integration, 2.5D/3D ICs, and MEMS devices. Typically, laser debonding of bonded pairs (R/R separation) is typically achieved by completely removing the material from the ablation region within the release material layer at high energy densities. However, this R/R separation method often results in a significant amount of release material and carbonized debris remaining on the surface of the device wafer, severely reducing product yields and cleaning efficiency for ultra-thin device wafers. Here, we proposed an interfacial separation strategy based on laser-induced hot stamping effect and thermoelastic stress wave, which enables stress-free separation of wafer bonding pairs at the interface of the release layer and the adhesive layer (R/A separation). By comprehensively analyzing the micro-morphology and material composition of the release material, we elucidated the laser debonding behavior of bonded pairs under different separation modes. Additionally, we calculated the ablation threshold of the release material in the case of wafer bonding and established the processing window for different separation methods. This work offers a fresh perspective on the development and application of laser debonding technology. The proposed R/A interface separation method is versatile, controllable, and highly reliable, and does not leave release materials and carbonized debris on device wafers, demonstrating strong industrial adaptability, which greatly facilitates the application and development of advanced packaging for ultra-thin chips.

Wafer Edge Process Integration and Defect Inspection with the Immersion Lithography Process

Immersion Barc for Hyper Na Applications Ii

Optimized Wafer Edge Condition in Lithographic Process for Peeling Defect Reduction

The Inspection and Solution of Inline CT Defect for 28NM Process Improvement

The Defect Reduction of Via Opens by the Integration of Inter-Metal-Dielectric Film, Metal Hard Mask, and All-in-One Etch Processes

Investigation and Discovery of the Integration of FEOL Process by Electron Beam Inspections

(Digital Presentation) Uniformity and Profile Improvement of Fin Etching Process at Wafer Extreme Edge for Finfet Mass Production

The Inline Detection of Tiny Bubble Defect and Solution for 14NM Photolithography Process

Novel Wafer Bevel Treatment for Water Immersion Lithography

The Study And Investigation Of Inline E-Beam Inspection For 28nm Process Development

Analysis of Linewidth Uniformity and Line Edge/Width Roughness in a 5 Nm Logic SAQP Process

Precise Modulation of the Debonding Behaviours of Ultra-Thin Wafers by Laser-Induced Hot Stamping Effect and Thermoelastic Stress Wave for Advanced Packaging of Chips

Wafer level microarcing model in 90nm chemical-vapor deposition low-k via etch on 300mm silicon-on-insulator substrate

Top Metal Layer Electro Plating Edge Bevel Removal Improvement Study

An Investigation of Edge Bead Removal Width Variability, Effects and Process Control in Photolithographic Manufacturing

Optimization of Wet strip after Metal Hard Mask All-in-One Etch for metal void reduction and yield improvement

Methods of Reducing Metal Damager Defect in Back End of Line for Semiconductor in 28nm Technology

Competing Behavior of Interface Delamination and Wafer Cracking During Peeling Film from Ultra-Thin Wafer

The Study and Investigation of Inline E-Beam Inspection for 28nm Process Window Monitor

The total inspection solutions of extreme tiny defect in BEOL advanced semiconductor process

From Computational Lithography to Computational Inspection: Inverse Lithography Technology (ILT) and Inverse Inspection Technology (IIT)