Abstract:Ultra-thin silicon slicing technology plays a critical role in achieving high-efficiency and low-cost solar cells in the photovoltaic (PV) industry. However, the surface phase evolution of silicon wafers under an ultra-thin slicing process and resulting etching behavior remains unclear. In this study, the surface phase evolution of different surface thicknesses of silicon wafers was carefully studied. As the thickness of silicon wafers became relatively thin, the degree of surface stress-induced amorphous silicon (ST-α-Si) significantly increased. Moreover, the UPS test showed that the ST-α-Si layer had an orbital energy level relatively lower than that in monocrystalline silicon, thereby having lower reduction performance during metal-assisted chemical etching (MACE). A copper deposition experiment was conducted to study the etching hindering effect caused by silicon surface ST-α-Si phases. The result showed that the presence of ST-α-Si adversely affected copper deposition. To improve the MACE uniformity, a pretreatment involving the use of HF/H 2 O 2 mixed solution to remove the surface ST-α-Si layer was investigated. After HF/H 2 O 2 pretreatment, the uniformity of inverted pyramids formed through MACE on the silicon wafer surface was significantly improved. Moreover, the reflectance of the MACE-textured surface was reduced to 7.67% from 10.1% compared with that without pretreatment. Therefore, this study provides reference guidelines and useful approaches for preparing uniform inverted pyramid surfaces using MACE in ultra-thin silicon wafers.

Optimization of Wet strip after Metal Hard Mask All-in-One Etch for metal void reduction and yield improvement

Investigation of Amorphous Silicon As Dry Etch Hard Mask in BEOL Low-k Dielectric Patterning

Research on Integrated Trench Etching for Trench-Type Power MOSFET

Metal hard-mask based AIO etch challenges and solutions

Total Solutions for 40nm Metal Hard-Mask All-In-One Etch Process

Optimized Wafer Edge Condition in Lithographic Process for Peeling Defect Reduction

The Defect Reduction of Via Opens by the Integration of Inter-Metal-Dielectric Film, Metal Hard Mask, and All-in-One Etch Processes

Metal corrosion and passivation swelling defect study of ultra low pattern density thick metal etch process

A Comprehensive study of reliability improvement for 65nm Cu/Low-k process

Top Metal Layer Electro Plating Edge Bevel Removal Improvement Study

Methods of Reducing Metal Damager Defect in Back End of Line for Semiconductor in 28nm Technology

Optimization of approach for metal contamination reduction

(Digital Presentation) Uniformity and Profile Improvement of Fin Etching Process at Wafer Extreme Edge for Finfet Mass Production

A study of post-etch wet clean on electrical and reliability performance of Cu/low k interconnections

28nm Metal Hard Mask etch process development

Industrial Challenges of TiN Hard Mask Wet Removal Process for 14nm Technology Node

A Low Cost and Residue-Free Abrasive-Free Copper Cmp Process with Low Dishing, Erosion and Oxide Loss

Step Coverage and Dry Etching Process Improvement of Amorphous Carbon Hard Mask

Effective Approaches to Improve Au Etching Process Performance in MEMS Devices

Research on Silicon Wafer Surface Phase under the Ultra-thin Slicing Process and Its Etching Hindrance Behavior during Metal-Assisted Chemical Etching

Copper Chemical Mechanical Polishing and Wafer Thinning with Temporary Bonding for Through Silicon Via Interconnect