Abstract:The mixed-lubrication is generated at the wafer-pad interface, and the wafer-pad interaction is very complex during CMP process. Therefore, it is very important to study and reveal the fluid lubrication behaviour and the wafer status during industrialized CMP process. In this study, the wafer status monitoring system is further developed for the integrated in-situ measurement system to monitor the wafer bending and the wafer orientation in addition with the fluid pressure during the dynamic polishing process. Using this in-situ measurement system, the fluid lubrication behaviour is studied for the CMP process of 12-inch wafer. The positive-dominated fluid pressure is observed, and the fluid pressure increases with the downforce. Furthermore, the wafer bending and the wafer orientation are studied using the in-situ measurement system. The results reveal that there exists a slightly convex wafer bending by the order of 10 micrometer and a positive pitch angle on the order of 10(exp -5)~10(exp -4) degree under uniform downforce, and the wafer bending and pitch angle increase almost linearly with the downforce. The effects of the downforce on the wafer bending and the pitch angle are accordant with that on the fluid pressure, which indicates that the wafer bending and the wafer orientation play important roles in the hydrodynamic lubrication of CMP. Keywords: Chemical mechanical polishing, Fluid lubrication, In-situ measurement, Fluid pressure, Wafer orientation, Wafer bending

Wafer Back Pressure Control and Optimization in the Cmp Process

CMP pressure control based on dual-modes controller

Identification Research on Cmp Multi-Zones Pressure System

Research on CMP Process Parameters Effect on Slurry Transport

Study on decoupling inverse control of CMP multi-zones pressure system

Effect of Zone Pressure on Wafer Bending and Fluid Lubrication Behavior During Multi-Zone Cmp Process

In Situ Measurement of Fluid Pressure at the Wafer-Pad Interface During Chemical Mechanical Polishing of 12-Inch Wafer

Analysis on Pad Effects in Chemical Mechanical Polishing

Numerical and Experimental Investigation on Multi-Zone Chemical Mechanical Planarization

Analysis on Contact and Flow Features in CMP Process

Contact Stress Non-Uniformity of Wafer Surface for Multi-Zone Chemical Mechanical Polishing Process

A Preliminary Model Accounting for the Suction Pressure in CMP Process

The Developed History on the Back Pressure Distribution of CMP Carrier

Chemical mechanical polishing: Theory and experiment

Low Downforce Copper Chemical Mechanical Polishing Distributed Control System

Experimental Studies on Interfacial Fluid Lubrication and Wafer Status During Chemical Mechanical Polishing of 12-Inch Wafer

Effects of the Polishing Variables on the Wafer-Pad Interfacial Fluid Pressure in Chemical Mechanical Polishing of 12-Inch Wafer

Optimization of Design of Experiment for Chemical Mechanical Polishing of A 12-Inch Wafer

Primary Study of the Carrier of CMP

Contribution of Porous Pad to Chemical Mechanical Polishing