Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Abnormal Discharge of No.1894 Tower in ±660 kV Yin-Dong HVDC Transmission Line and the Countermeasures

Field Monitoring and Analysis on Vibration and Noise Characteristics of AC Transformer Caused by ± 660kv Yin‐dong DC System

Experimental Research on Hot-line Work of 750 Kv Single Compact Power Transmission Line

Simulated Calculation and Analysis of Lightning Performance of UHV A.C. Transmission Line

Research on Power Frequency Over-Voltage in UHV AC Transmission Lines

Comparative Research on Z-Type Tower and Traditional T-Type Tower for UHVDC Transmission Lines Located at Mountain Areas

Analysis on Overvoltage in Renovated Control and Protection System for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Lightning Performance of Quadruple-circuit Transmission Line with Dual Voltage 500/220 Kv on the Same Tower

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station

Study on Transient Overvoltage of Zhexi Converter Station of ±800 Kv DC Power Transmission Project

DISCUSSION ON SEVERAL IMPORTANT PROBLEMS OF DEVELOPING UHV AC TRANSMISSON IN CHINA

Research on the Electromagnetic Environment of 220 Kv Four Circuits on One Tower Transmission Line

DC switching overvoltage of ± 1100 kV UHVDC converter station

Impact of zero-sequence mutual inductance in UHV Anhui-to-east power transfer lines on phase-earth distance protection

Applicable occasions of UHVAC/UHVDC transmission and their technology comparisons in China

Single-phase grounding overvoltage of long-distance UHVAC lines

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Corona Discharge of Practical Operated Transmission AC Lines

Peculiar Technology Problems of UHV in China

Analysis on the Operation Risk and Its Regulation Measures of Yunnan Power System Connected with Yunnan-Guangdong ±800 kV DC Transmission Line

Lightning Withstand Performance of the Yun-guang ±800kv UHVDC Power Transmission Line