Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Field Monitoring and Analysis on Vibration and Noise Characteristics of AC Transformer Caused by ± 660kv Yin‐dong DC System

A study on monitoring technology for multi-terminal ±500kV VSC-HVDC power transmission system

Influence of DC Transmission on Transformers in AC System

Influence of Hvdc Ground Electrode Current on Ac Transmission System and Its Restraining Measure

Research on transient overvoltage for converter station of Zhoushan multi-terminal VSC-HVDC project

On the DC Transient Overvoltage in the Converter Stations of ±800 Kv Xiluodu Zhexi HVDC Project

DC switching overvoltage of ± 1100 kV UHVDC converter station

Simulation and analysis of induced voltage and induced current on overhead ground wire of Jindongnan-Nanyang-Jingmen 1000kV UHV AC transmission line

Vibration and Audible Noise Characteristics of AC Transformer Caused by HVDC System under Monopole Operation

Analysis on Overvoltage in Renovated Control and Protection System for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Analysis and Mitigation of Low-Frequency Resonance in a Long-Distance UHVDC ±1100 Kv System

Influence and Characteristics Analysis of Effect Of the HVDC Ground Return Current on AC System

Analysis and Measurement Methods of Transformer Vibration and Noise Characteristics

Low Frequency Resonance Analysis of ±1100 Kv HVDC System

Abnormal Discharge of No.1894 Tower in ±660 kV Yin-Dong HVDC Transmission Line and the Countermeasures

Simulation and Analysis of High Frequency Harmonic Components of Voltage and Current of Converter Transformer in Flexible DC System

Vibration Characteristics of ±800 Kv Converter Transformers Part I: under No-Load Conditions

Vibration Characteristics of ± 800 Kv Converter Transformers Part II: under Load Conditions

Vibration and Noise Characteristics of Air-Core Reactor Used in HVDC Converter Stations

Study on Electromagnetic Environment of ±800 Kv UHV DC and 1000 Kv UHV AC Parallel Transmission Lines