Abstract:Direct electrodeposition (ECD) process of copper film on ultra-thin molybdenum film is investigated in both copper sulfate - sulfuric acid (CuSO4 - H2SO4) acidic bath and copper sulfate - ethylenediamine (CuSO4 - En) neutral bath (pH=7.5). The neutral electrolyte containing 0.03M CuSO4 and 0.06M En was chosen to avoid excessive corrosion of Mo and introduction of other ions. The complexing effect of En affects the electrodeposition process of Cu on Mo. Potentiodynamic polarization curves and scanning electron microscopic characterization show that Cu can be electroplated in CuSO4 - En bath with lower corrosion rate, greater nucleation density and shorter fully-covering time than that in CuSO4 - H2SO4 bath. The fitting results of current-time transients using Scharifker and Hill's model support the instantaneous nucleation and growth of Cu on Mo in both CuSO4 - H2SO4 bath and CuSO4 - En bath (with background electrolyte) at the initial stage of electrodeposition. By using an optimized two-step plating process (at the current density of 8mA/cm2 in the first step for a short time and 4mA/cm2 in the second step), the resistivity of direct ECD Cu on Mo was almost the same to that of ECD Cu on Cu/Mo in the same plating bath. Display Omitted The direct electrodeposition of Cu on Mo in neutral bath was reported originally.Corrosion rate of Mo is much lower in neutral bath than that in acidic bath.Hemispherical Cu nuclei are achieved in neutral bath rather than dendritic ones.The density Cu nuclei on Mo in neutral bath is much higher than that in acid bath.A two-step plating process was applied to lower the resistivity of direct ECD Cu.

Effect of Coxmoy As Single Barrier Layer on Properties of Directly Electroplated Copper Films

Barrier layer dependence of self-annealing effect in directly electroplated copper films

Direct copper plating on ultra-thin sputtered cobalt film in an alkaline bath

Properties of Directly Electroplated Copper on CoMo Alloy Diffusion Barrier

Direct copper electrodeposition on novel CoMo diffusion barrier

Electrodeposition of Cu on CoTa Barrier in the Alkaline CuSO4-Ethylenediamine Solution

Study of Direct Cu Electrodeposition on Ultra-Thin Mo for Copper Interconnect

The Oxygen Barrier Properties of CoxMoy Diffusion Barrier for Cu Interconnect

Study of A Single Layer Ultrathin Como Film As A Direct Plateable Adhesion/Barrier Layer for Next Generation Interconnect

Investigation of the Behaviors of Various Electroplated Copper Films During CMP

XRD Study on Cu Layer in IC Interconnect

Evolution of texture in electrodeposited Ni/Cu layered nanostructures

The Influence of Cu on the Corrosion Resistance of Electroless Ni-Cu-P Deposits on Al Substrate

Influence of Complexing Agents on Texture Formation of Electrodeposited Copper

Interface Reliability and Diffusion Barrier Property of Co-W Barrier Layer with Modulated Structure

Competitive Effect of Leveler's Electrochemical Behavior and Impurity on Electrical Resistance of Electroplated Copper

Effects of 2-Mercaptopyridine and Janus Green B As Levelers on Electrical Resistance of Electrodeposited Copper Thin Film for Interconnects

Influence of IMP Copper Flash Layer on the Properties of Copper Films Deposited by Metal Organic Chemical Vapor Deposition

Study on CMP of Copper Interconnect with Novel Mo-Based Diffusion Barriers

Behavior of Copper Removal by CMP and Its Correlation to Deposit Structure and Impurity Content

Electrodeposition, Structural, and Corrosion Properties of Cu Films from A Stable Deep Eutectics System with Additive of Ethylene Diamine