Abstract:A Monte Carlo Potts model, including anisotropic boundary energies and mobilities, has been used to investigate cube texture evolution. The work is motivated by the post-recrystallization grain growth seen during annealing of highly cold-rolled nickel sheets, It is observed that during such grain growth the cube texture fraction increases from approx. 50% to more than 95%. Electron back-scatter diffraction orientation measurements of fully recrystallized samples have been used to provide starting microstructures for simulations examining the effect of the texture tightness on the development of the cube texture during grain growth. The texture evolution of a single texture component with an initial average size advantage is controlled predominantly by this size advantage once the initial texture spread of this component falls below some value. An additional set of simulations was also carried out to examine grain growth in systems with a quasi-binary texture. The simulations were used to examine cases of grain growth in where one component has a larger average grain size, but where there is still a significant overlap in the grain-size distribution of each component. The initial microstructures were constructed to give different fractions of each texture component, with a given value of both the mean size and the texture spread of each component. The simulations suggest that for such systems there is a well defined range of conditions for which a single texture component can grow to dominate the final texture.

Evolution of texture in electrodeposited Ni/Cu layered nanostructures

Preparation of highly (111) textured nanotwinned copper by medium-frequency pulsed electrodeposition in an additive-free electrolyte

An Ex-Situ Study on Epitaxial Growth of Nickel on Copper Substrate in Electrodeposition

Systematic investigation of the texture evolution of Cu-Ni alloys with different strains

Electron microscope study of electrodeposited Ni films in the 0.1–50 μ range

Cuprite Nanowires by Electrodeposition from Lyotropic Reverse Hexagonal Liquid Crystalline Phase

Structure and Properties of Electrocodeposited Cu-Al2o3 Nanocomposite Thin Films

Development of the Cube Texture at Low Annealing Temperatures in Highly Rolled Pure Nickel

Effect of different deformation and annealing procedures on non-magnetic textured Cu60Ni40 alloy substrates

Electrochemical co-deposition of carbon nanotube/Ni composite layer

Epitaxial (111) Films of Cu, Ni, and Cu$_xNi$_y$ on α-Al$_2$O$_3$(0001) for Graphene Growth by Chemical Vapor Deposition

Recrystallization Texture in Nickel Heavily Deformed by Accumulative Roll Bonding

Ion-Beam Bombardment Induced Texture in Nickel Substrates for Coated High-T-C Superconductors

Biaxially Textured Ceo2 Seed Layers and Thin Films on Ni Substrates by Chemical Solution Deposition Using Inorganic Cerium Nitrate As A Precursor

Anomalous vertical twins with high (2 2 0) texture in direct current electroplating copper film

Nanoscale Metal/Metal Multilayers Electrodeposited from Ethaline

Microstructure and Texture Evolution of Cu-Ni-P Alloy after Cold Rolling and Annealing

Electrochemical study and structural comparison of Ni electrodepositions on W/Si and Cr/C multilayered structure films

Graphene Growth by Chemical Vapour Deposition on Cross-Rolled Surface Textured Nickel-Copper Foils

Development and Stability During High Temperature Annealing of the Cube Texture in Rolled Ni Substrate Materials

Modeling of Cube-Texture Evolution During Grain Growth in Ni Thick-Films Based on Experimental Observations