Abstract:The electrodeposition of a Cu–Sn binary alloy on stainless steel from a cyanide-free alkaline electrolyte containing EDTA·2Na and C4H4O6KNa was investigated to explore the possibility of a cyanide-free double complexing system that maintains the decorative quality and coating performance. The Cu–Sn co-deposition occurred at −0.95 Vvs.Hg|HgO, and the height of cathode peak A from the BR bath was −0.0280 A. EDTA·2Na could simultaneously complex with Cu ions and Sn ions, while C4H4O6KNa could only complex with Cu ions, which was shown through the analysis of the cyclic voltammetry (CV) curves together with the nuclear magnetic resonance (NMR) results. The molar concentration ratio and sum of the two main salts or the two complexing agents, and the pH of the electroplating solutions were shown to influence the surface micromorphology, composition and phase structure of the Cu–Sn coatings. The scanning electron microscopy (SEM) analysis showed that the Cu–Sn coating obtained from the bath with EDTA-tartrate double complexing agents exhibited smaller grain sizes than that obtained from the bath with the single EDTA or tartrate complexing agent, and the smallest grain size of 0.2 μm was obtained from the BR bath. In addition to being smaller than the others, this coating contained uniform particle sizes. The energy-dispersive X-ray spectroscopy (EDS) analysis indicated that the composition of the Cu–Sn coating obtained from the BR bath was 92.8 wt% Cu and 7.2 wt% Sn, and this coating was golden in colour. X-ray diffraction (XRD) showed that the Cu–Sn coatings were crystalline and were composed of a mixture of Cu, Cu6Sn5, [Cu, Sn] and Cu10Sn3 phases, indicating the formation of Cu–Sn binary alloy. These results may provide theoretical guidance for the electrodeposition technology of other alloy coatings.

Electrodeposition of Cu on CoTa Barrier in the Alkaline CuSO4-Ethylenediamine Solution

Direct copper plating on ultra-thin sputtered cobalt film in an alkaline bath

Direct copper electrodeposition onto cobalt adhesion layer in alkaline bath

Direct copper electrodeposition on novel CoMo diffusion barrier

Acidic Electroless Cu Deposition in Cuso4-Nh4f Solution

Effect of Coxmoy As Single Barrier Layer on Properties of Directly Electroplated Copper Films

Study of Direct Cu Electrodeposition on Ultra-Thin Mo for Copper Interconnect

Electrodeposition of Nanostructured Co–Cu Thin Alloy Films on to Steel Substrate from an Environmentally Friendly Novel Lactate Bath under Different Operating Conditions

Electroless Cu Deposition on a TiN Barrier in CuSO[sub 4]-HF Solution

Electroless Deposition of Pure Co on TaN Substrate for Interconnect Metallization

Superconformal Copper Electroplating on an Ultrathin Cobalt Seed in an Acidic Copper Sulfate Electrolyte

Sn/Pd Catalyzation and Electroless Cu Deposition on TaN Diffusion Barrier Layers

Effects of Fe(III) and Cu(I) on Electrodeposition and Microstructure Characterization for Acid Plating Bath

Direct, Sequential Growth of Copper Film on TaN/Ta Barrier Substrates by Alternation of Pb-UPD and Cu-SLRR

Electroless acid-based plating Cu on TiNi/Ti/SiO2/Si substrate

Effect of pH on the electrodeposition nucleation and growth mechanism of cuprous oxide

Study on alkaline and acid-alkaline chemical plating of Cu

Electrodeposition of High-Quality Cr Coatings with Solid Solution Al from Cr2+ Electrolyte

Behavior of Electroless Cu Deposition in CuSO[sub 4]-HF Solution

The electrodeposition of low-Sn imitation gold Cu–Sn alloy from EDTA-tartrate double complexing agents

Study on Cu-Sn Alloy Electrodeposition