Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

A Wafer-Level Characterization Method of Esd Protection Circuits for Both Component-Level and System-Level Applications

Electro-Thermo-Mechanical Investigation On Multi-Level Interconnects In The Presence Of An Esd Pulse

Modeling Study of Power-On and Power-Off System-Level Electrostatic Discharge Protection

Investigation Of Waffle Structure Scr For Electro-Static Discharge (Esd) Protection

Study of Turn-on Characteristics of SCRs for ESD Protection with TDR-O and TDR-S TLPs

A Novel and Powerful TCAD Methodology to Evaluate Performance of ESD Protection Devices

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Analyse of Protection Devices' Speed Performance against ESD under CDM Using TCAD

Evaluation of RF electrostatic discharge (ESD) protection in 0.18-μm CMOS technology

Design of a Novel Static-Triggered Power-Rail ESD Clamp Circuit in a 65-Nm CMOS Process

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

ESD Circuits Design for High-Speed Analog CMOS Integrated Circuits

A capacitance coupling complementation SCR for on-chip electrostatic discharge protection

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

Characterizing Phase Switching Structures for ESD Protection

Co-design Circuit Simulation to Investigate the Failure of Devices under Surge Stress

An Investigation on Capacitance-Trigger ESD Protection Devices for High Voltage Integrated Circuits

Novel Electrostatic Discharge Protection Design Method

On the ESD Protection and Non-Fatal ESD Strike on Nano CMOS Devices

Circuit-level ESD Protection Simulation Using Behavior Models in 28nm CMOS

Design of Power-Rail ESD Clamp Circuit with Separate Detection Component and Delay Component Against Mis-Triggering