Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

ESD Circuits Design for High-Speed Analog CMOS Integrated Circuits

Analysis of 65 Nm Technology Grounded-Gate NMOS for On-Chip ESD Protection Applications

A Systematic Study of ESD Protection Co-Design with High-Speed and High-Frequency ICs in 28 Nm CMOS.

Power System ESD Protection Circuit Design in CMOS IC

Design and Analysis of an Area-Efficient High Holding Voltage ESD Protection Device

A Novel On-Chip Electrostatic Discharge Protection Design for Rf Ics

On the ESD Protection and Non-Fatal ESD Strike on Nano CMOS Devices

Novel Electrostatic Discharge Protection Design Method

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

New Electrostatic Discharge Protection Device for VBO High Speed Chip

Power Bus ESD Protection Structure Design in CMOS IC

Analyse of Protection Devices' Speed Performance against ESD under CDM Using TCAD

Evaluation of RF electrostatic discharge (ESD) protection in 0.18-μm CMOS technology

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

A novel power-clamp assisted complementary MOSFET for robust ESD protection.

Ggnmos As Esd Protection in Different Nanometer Cmos Process

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

Electrostatic Discharge Protection Framework for Mixed-Signal High Voltage CMOS Applications

An Overview of ESD Protection in Nanometer IC

FOD Based ESD Protection Devices in Deep Sub-micron Technology

On-Chip ESD Protection Design for Ics