Abstract:The trigger voltage walk-in effect has been investigated by designing two different laterally diffused metal—oxide—semiconductor (LDMOS) transistors with an embedded silicon controlled rectifier (SCR). By inserting a P+ implant region along the outer and the inner boundary of the N+ region at the drain side of a conventional LDMOS transistor, we fabricate the LDMOS-SCR and the SCR-LDMOS devices with a different triggering order in a 0.5 μm bipolar-CMOS-DMOS process, respectively. First, we perform transmission line pulse (TLP) and DC-voltage degradation tests on the LDMOS-SCR. Results show that the trigger voltage walk-in effect can be attributed to the gate oxide trap generation and charge trapping. Then, we perform TLP tests on the SCR-LDMOS. Results indicate that the trigger voltage walk-in effect is remarkably reduced. In the SCR-LDMOS, the embedded SCR is triggered earlier than the LDMOS, and the ESD current is mainly discharged by the parasitic SCR structure. The electric potential between the drain and the gate decreases significantly after snapback, leading to decreased impact ionization rates and thus reduced trap generation and charge trapping. Finally, the above explanation of the different trigger voltage walk-in behavior in LDMOS-SCR and SCR-LDMOS devices is confirmed by TCAD simulation.

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

Evaluation of RF electrostatic discharge (ESD) protection in 0.18-μm CMOS technology

Design Analysis of a Novel Low Triggering Voltage Dual Direction SCR ESD Device in 0. 18μm Mixed Mode RFCMOS Technology

A Novel Dual-Directional DTSCR in Twin-Well Process for Ultra-Low-voltage ESD Protection

Investigation of Boundary-Mos-triggered SCR Structures for On-Chip ESD Protection

Inverstigation of high turn-on speed MOS-Triggered SCR in 0.13μm CMOS process

A novel straight through-MOS-triggered SCR for on-chip ESD protection

Vertical Silicon-Controlled Rectifier for ESD Protection under 28nm Ps Process

An Investigation on Capacitance-Trigger ESD Protection Devices for High Voltage Integrated Circuits

Low-Capacitance SCR Structure for RF I/O Application

Very Small Snapback Silicon-Controlled Rectifier for Electrostatic Discharge Protection in 28 Nm Processing.

Novel Capacitance Coupling Complementary Dual-Direction SCR for High-Voltage ESD

A Novel Capacitance-Coupling-Triggered SCR for Low-Voltage ESD Protection Applications

RC-Embedded LDMOS-SCR with High Holding Current for High-Voltage I/O ESD Protection

An Area-Efficient LDMOS-SCR ESD Protection Device for the I/O of Power IC Application

Key factors affecting trigger voltage of SCRS for ESD protection

A capacitance coupling complementation SCR for on-chip electrostatic discharge protection

Whole Chip Esd Protection for 2.4 Ghz Lna

New Electrostatic Discharge Protection Device for VBO High Speed Chip

Whole Chip ESD Protection Design for 2.4 GHz LNA

Investigation of the Trigger Voltage Walk-In Effect in Ldmos for High- Voltage Esd Protection