Abstract:As the characteristic size of semiconductor devices in ICs decreases, ICs are becoming more sensitive to electrostatic discharge (ESD). Electrostatic protection has become one of the most important reliability indexes in ICs, and the ESD protection structure has also become a difficult problem in chip design. A sensor exposed to static electricity can be damaged and its output signal can be disturbed. Therefore, electrostatic protection also plays an important role in sensors. As the scale of ICs increases, the number of chip pins is increasing and a larger area is being used for ESD protection circuits, resulting in higher costs. Silicon controlled rectifier (SCR) ESD protection devices have the highest performance per unit area among the known ESD protection structures, and are thus the first choice for low-cost, on-chip ESD design solutions. In this study, through a Sentaurus simulation, two SCRs with different structures (a directly connected SCR and a modified lateral SCR) are established, and transmission line pulse tests are carried out on the two devices. The key characteristic indexes are analyzed theoretically and by using experimental data. According to the simulation results, the opening voltage of the directly connected SCR is about 1.5 V and its secondary breakdown current is above 5 A, indicating that the device has a high protection level.

Whole Chip ESD Protection Design for 2.4 GHz LNA

Whole Chip Esd Protection for 2.4 Ghz Lna

Evaluation of RF electrostatic discharge (ESD) protection in 0.18-μm CMOS technology

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

Low-Capacitance SCR Structure for RF I/O Application

Improvement on Diode String Structure for 65-Nm RF ESD Protection

An Area-Efficient LDMOS-SCR ESD Protection Device for the I/O of Power IC Application

Improved Low-Voltage-Triggered Scr Structure for Rf-Esd Protection

A Novel SCR ESD Protection Structure for RF Power Amplifier

A 5kv Esd-Protected 2.4ghz Pa in 180nm Rfcmos Optimized by Esd-Pa Co-Design Technique

An ESD-Aware 2.4 GHz PA Design for WLAN Application

Design of ESD Protection for Low Noise Amplifier through Matching Network

A novel straight through-MOS-triggered SCR for on-chip ESD protection

Complementation SCR for RF IC ESD protection (Electromagnetism)

Complementation SCR for RF IC ESD Protection

Vertical Silicon-Controlled Rectifier for ESD Protection under 28nm Ps Process

Design Analysis of a Novel Low Triggering Voltage Dual Direction SCR ESD Device in 0. 18μm Mixed Mode RFCMOS Technology

A Robust Polysilicon-Assisted SCR in ESD Protection Application

Co-design of ESD protection and LNA in RFIC

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

High-performance Electrostatic Discharge Protection Device for Power Chip Based on 28 Nm Process