Abstract:This paper deals with the fabrication of an inductorless wideband low-noise amplifier (LNA). The LNA includes two branches in parallel: a common-source (CS) path and a common-gate (CG) path. The CS path is responsible for providing enough power gain, while the CG path is used to achieve the input impedance matching. To eliminate the noise contribution of the CG path, the noise cancellation technique is applied. Therefore, the overall noise figure (NF) is improved. The phase mismatch between the two paths is also quantitatively analyzed to investigate its effect on gain and NF. The analytical results agree well with the simulation results. The LNA has been fabricated by a commercial 0.18-mu m CMOS process. The measurement results show that the LNA has achieved a maximum gain of 14.5 dB with 1.7-GHz 3-dB gain bandwidth and a minimum NF of 3 dB. The tested input 1-dB gain compression point (IP1 dB) is -10.4 dBm at 1 GHz and the input third-order intercept point is 0.25 dBm. With 1.8-V supply, the LNA draws only 6-mA dc current.

Design of ESD Protection for Low Noise Amplifier through Matching Network

Whole Chip ESD Protection Design for 2.4 GHz LNA

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Whole Chip Esd Protection for 2.4 Ghz Lna

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Miller Effect Analysis and Noise Optimization of CMOS Low Noise Amplifier

Low noise amplifier module with active bias using system in package technology

5 GHz LNA based on CHRT 0.18 μm CMOS technology

A Wideband BiCMOS Thermal Noise Canceling Low Noise Amplifier with Temperature Compensation

Design And Simulation Of Low Noise Amplifier For Radio Frequency Front End Of Wireless Communication

A 140 GHz, 4 Db Noise-Figure Low-Noise Amplifier Design with the Compensation of Parasitic Capacitance CGS

A Low-Power ESD-protected 24ghz Receiver Front-End with &Amp;#x03c0;-Type Input Matching Network

Gain-controlled CMOS Low Noise Amplifier

Design of 24-Ghz High-Gain Receiver Front-End Utilizing ESD-Split Input Matching Network

A 3.4 Db Nf K-Band Lna with A Tapped Capacitor Matching Network in 65 Nm Cmos Technology

An ESD-Aware 2.4 GHz PA Design for WLAN Application

A Wideband Low Noise Amplifier for Ultra Wide Band System

A low power single ended input differential output low noise amplifier for L1/L2 band