Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A 3.4 Db Nf K-Band Lna with A Tapped Capacitor Matching Network in 65 Nm Cmos Technology

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

0.9–10GHz low noise amplifier with capacitive cross coupling

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

A 3.4db NF K-Band LNA in 65nm CMOS Technology

A 18–44 GHz Low Noise Amplifier with Input Matching and Bandwidth Extension Techniques

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

A 23-30 GHz LNA with Noise-Cancelling in 28nm CMOS

An analytical approach to designing millimeter‐wave LNAs with transformer‐based matching networks

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A wideband inductorless LNA exploiting three-stage feedback and thermal noise canceling

A 18–33 GHz CMOS LNA with 26.7 dB peak gain and 2.8 dB minimum NF for K/Ka-band applications

A 140 GHz, 4 Db Noise-Figure Low-Noise Amplifier Design with the Compensation of Parasitic Capacitance CGS

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

A 2-V 1.4-dB NF GaAs MMIC LNA for K-Band Applications

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS