Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

5 GHz LNA based on CHRT 0.18 μm CMOS technology

1.9&Amp;amp;#x223c;2.6ghz Tuning Range Variable Gain Low-Noise Amplifier with Digital Assisted Automatic Tuning Loop

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

A dual band CMOS two-stage variable gain low noise amplifier

A 140-Gbps 1-to-21-ghz Ultra-Wideband LNA Achieving 1.95-to-3-db NF Using Gm-Assisted-Feedback Noise Suppression Technique in 40nm Bulk CMOS

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

A 0.9/1.8/2.4Ghz-Reconfigurable LNA with Inductor and Capacitor Tuning for IoT Application in 65nm CMOS

A 0.1-4Ghz Reconfigurable Multi-band CMOS LNA for SDR Applications

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

A 0.061-mm2 1–11-GHz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward With Simultaneous Current and Noise Reduction

A CMOS 0.5&#x2013;10.6 GHz Inductor Feedback Low Noise Amplifier for Multi-Standard Application