Abstract:This article reports a high-gain wideband low-noise amplifier (LNA) with single ended input and differential output for multi-standard wireless receiver operating in 0.2 to 7 GHz. The proposed balun-LNA is cascode structure with common-gate–common-source (CG–CS) balun load to achieve single to differential conversion. Focusing on improving the voltage gain, bandwidth and noise performance at the same time, several techniques are implemented in this balun-LNA. A current source is added shunting CG stage to relieve voltage headroom and improve gain and linearity. Wideband input matching is achieved by active shunt-shunt resistive feedback, together with the input series inductor. Moreover, feedforward and current-reuse technique are introduced to further optimize the noise performance. The proposed LNA has a measured voltage gain of 26 dB which is nearly 6 dB higher than other balun-LNA with same supply and process. Moreover, the minimum noise figure (NF) is 2.0 dB owing to multiple noise-optimized technique. The achieved input power at 1 dB gain compression point (IP1 dB) is −14 dB m at 1 GHz and input return loss ( S11 ) is better than −10 dB across entire operating frequency range. IIP3 and IIP2 achieve −7 dBm and 25 dBm respectively, measured at 1 GHz. The power consumption is 15.5 mW at 1.2 V supply. The LNA is fabricated in 130 nm CMOS process and the active area is 0.097 mm2 . The LNA achieves high voltage gain and wide operating frequency range with low NF, which can be reflected from the figure of merit (FOM) of 23.1.

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Gm-boosted and current peaking wideband merged LNA and mixer

A Broadband Variable-Gain Low-Noise Amplifier With Low NF and Dual Phase Compensation

A Wideband Cmos Variable-Gain Low Noise Amplifier with Novel Attenuator

A High Linearity Variable Gain LNA for WCDMA Receiver Front-End

A 6-18Ghz Low-Noise Amplifier Using Noise Canceling Technique in 130-Nm CMOS PD-SOI.

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

1.9&Amp;amp;#x223c;2.6ghz Tuning Range Variable Gain Low-Noise Amplifier with Digital Assisted Automatic Tuning Loop

A 33.5–39 GHz 5-Bit Variable Gain LNA with 4 Db NF and Low Phase Shift

A 21-to-41-GHz High-Gain Low Noise Amplifier With Triple-Coupled Technique for Multiband Wireless Applications

A high-gain wideband balun-LNA with multiple noise-optimized technique

A Compact LNA with 23.3 dB Gain and 3.4 dB NF for V-Band Phased Array Systems in 65-nm CMOS Technology

A 28 GHz balun‐first LNA with db‐linear 32 db gain range for 5 G applications

A 70–86-Ghz Deep-Noise-Canceling LNA with Dual-Stage Noise Cancellation Using Asymmetric Compensation Transformer and 4-to-1 Hybrid-Phase Combiner

A high gain-flatness C-band variable gain LNA in a 0.25 μm GaAs pHEMT process

Design of a Novel Monolithic Multi-Octave-Frequency-band Low Noise Amplifier with Adjustable Gain-equalizing Characteristic