Abstract:This article reports a high-gain wideband low-noise amplifier (LNA) with single ended input and differential output for multi-standard wireless receiver operating in 0.2 to 7 GHz. The proposed balun-LNA is cascode structure with common-gate–common-source (CG–CS) balun load to achieve single to differential conversion. Focusing on improving the voltage gain, bandwidth and noise performance at the same time, several techniques are implemented in this balun-LNA. A current source is added shunting CG stage to relieve voltage headroom and improve gain and linearity. Wideband input matching is achieved by active shunt-shunt resistive feedback, together with the input series inductor. Moreover, feedforward and current-reuse technique are introduced to further optimize the noise performance. The proposed LNA has a measured voltage gain of 26 dB which is nearly 6 dB higher than other balun-LNA with same supply and process. Moreover, the minimum noise figure (NF) is 2.0 dB owing to multiple noise-optimized technique. The achieved input power at 1 dB gain compression point (IP1 dB) is −14 dB m at 1 GHz and input return loss ( S11 ) is better than −10 dB across entire operating frequency range. IIP3 and IIP2 achieve −7 dBm and 25 dBm respectively, measured at 1 GHz. The power consumption is 15.5 mW at 1.2 V supply. The LNA is fabricated in 130 nm CMOS process and the active area is 0.097 mm2 . The LNA achieves high voltage gain and wide operating frequency range with low NF, which can be reflected from the figure of merit (FOM) of 23.1.

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Broadband Variable-Gain Low-Noise Amplifier With Low NF and Dual Phase Compensation

A 6-18Ghz Low-Noise Amplifier Using Noise Canceling Technique in 130-Nm CMOS PD-SOI.

A dual band CMOS two-stage variable gain low noise amplifier

A Compact LNA with 23.3 dB Gain and 3.4 dB NF for V-Band Phased Array Systems in 65-nm CMOS Technology

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

1.9&Amp;amp;#x223c;2.6ghz Tuning Range Variable Gain Low-Noise Amplifier with Digital Assisted Automatic Tuning Loop

A Wideband Cmos Variable-Gain Low Noise Amplifier with Novel Attenuator

A Branch-Gain-Balanced LNA Based on Voltage- Controlled Resistor Feedback and Shared CMFB Amplifier

A 0.061-mm2 1–11-GHz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward With Simultaneous Current and Noise Reduction

A 12.87-dB Gain 10.5-dBm OP<inf>ldB</inf>60-to-66-GHz LNA in 0.15-μm GaAs pHEMT Technology

A 21-to-41-GHz High-Gain Low Noise Amplifier With Triple-Coupled Technique for Multiband Wireless Applications

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

A high-gain wideband balun-LNA with multiple noise-optimized technique