Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

A 140-Gbps 1-to-21-ghz Ultra-Wideband LNA Achieving 1.95-to-3-db NF Using Gm-Assisted-Feedback Noise Suppression Technique in 40nm Bulk CMOS

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A Gm-boosted and current peaking wideband merged LNA and mixer

0.9–10GHz low noise amplifier with capacitive cross coupling

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Design of a Broadband Ka-band MMIC LNA Using Deep Negative Feedback Loop.

A 18–44 GHz Low Noise Amplifier with Input Matching and Bandwidth Extension Techniques

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

An Ultra-Compact 84.9-107Ghz LNA with 4.9db NF by Utilizing Coupled-line-based Gm-Boosting and Noise-Canceling Techniques in 65-Nm CMOS Technology

A wideband inductorless LNA exploiting three-stage feedback and thermal noise canceling

A 1.0–5.0ghz Tunable LNA with Automatic Frequency Calibration in 65 Nm CMOS

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

A 0.18 Mu M Cmos Ultra-Wideband Low-Noise Amplifier With High Iip3

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

A 22-40.5 GHz UWB LNA Design in 0.15um GaAs.

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A 4.7-to-18-ghz Ultra-Wideband Variable-Gain Balun-LNA Using 3 Rd -Order-band-pass Input Matching in 40-Nm CMOS.