Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

28 GHz Compact LNAs with 1.9 Db Minimum NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques for Phased Array Systems

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Design of a Broadband Ka-band MMIC LNA Using Deep Negative Feedback Loop.

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A 54.4–90 GHz Low-Noise Amplifier in 65-nm CMOS

A Compact LNA with 23.3 dB Gain and 3.4 dB NF for V-Band Phased Array Systems in 65-nm CMOS Technology

A 37-to-41.8 GHz Double-Gm-Boosting LNA with 2.9-Db NFmin Using Quadruple-Coupling Transformer for Phased-Array Transceivers.

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

Millimeter-Wave Low-Noise Amplifier Design in 28-nm Low-Power Digital CMOS

A 18–44 GHz Low Noise Amplifier with Input Matching and Bandwidth Extension Techniques

A 21-to-41-GHz High-Gain Low Noise Amplifier With Triple-Coupled Technique for Multiband Wireless Applications

Ultralow Noise Figure and Broadband CMOS LNA With Three-Winding Transformer and Large Transistor

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

A 28-nm E-band low noise amplifier with minimum 3.8 dB noise figure