Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Design of a Novel Static-Triggered Power-Rail ESD Clamp Circuit in a 65-Nm CMOS Process

Power-rail ESD Clamp Circuit with Hybrid-Detection Enhanced Triggering in a 65-Nm, 1.2-V CMOS Process.

A Novel Low-Leakage ESD Power Clamp Circuit with Adjustable Transient Response Time

A Novel Low-Leakage Power-Rail Esd Clamp Circuit with Adjustable Triggering Voltage and Superior False-Triggering Immunity for Nanoscale Applications

Area-Efficient Power-Rail ESD Clamp Circuit with False-Trigger Immunity in 28nm CMOS Process

Design of Power-Rail ESD Clamp Circuit with Separate Detection Component and Delay Component Against Mis-Triggering

Area-efficient Transient Power-Rail Electrostatic Discharge Clamp Circuit with Mis-Triggering Immunity in a 65-Nm CMOS Process

A False Trigger-Strengthened and Area-Saving Power-Rail Clamp Circuit with High ESD Performance

Area-saved and Low-Leakage Design of Power-Rail Clamp Circuit

Power-Rail Esd Clamp Circuit With Parasitic-Bjt And Channel Parallel Shunt Paths To Achieve Enhanced Robustness

A novel multi-RC-triggered power clamp circuit for on-chip ESD protection

A Prolonged Discharge Time ESD Power-Rail Clamp Circuit Structure with Strong Ability to Prevent False Triggering

A Low Leakage Power-Rail ESD Clamp Circuit with Adjustable Holding Voltage in Nanoscale Process

A Novel Capacitance-Coupling-Triggered SCR for Low-Voltage ESD Protection Applications

Transient and Static Hybrid-Triggered Active Clamp Design for Power-Rail ESD Protection

A Low-Leakage Power Clamp ESD Protection Circuit with Prolonged ESD Discharge Time and Compact Detection Network.

An Investigation on Capacitance-Trigger ESD Protection Devices for High Voltage Integrated Circuits

Design and Verification of a Novel Multi-Rc-triggered Power Clamp Circuit for On-Chip ESD Protection

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

A New Static Power Clamp Co-Designed with Input ESD Protection Circuit

Improved Low-Voltage-Triggered Scr Structure for Rf-Esd Protection