Abstract:The temperature distribution in the reactor, especially on the surface of the wafer, is the important factors influencing the chemical reaction in CVD and PECVD process. This paper focused on a typical cylindrical PECVD reactor carrying with a wafer, and established the combination calculation model, which divided the chamber system into two calculation domains according to the rarefied degree of the gases. A one-dimensional thermal model was developed to calculate the temperature profiles in the narrow gap between the wafer and the heater, considering the heat conduction, radiation and thermal accommodation phenomenon between the gas and the surfaces in low pressure conditions; a two-dimensional axisymmetric model was applied to calculate the temperature profiles in the chamber above the wafer, considering the heat conduction, radiation and mass transfer. We verified the validity of the model through the experimental measurement in different pressure with the aluminum matrix pedestal and the one without. The experiment and numerical calculation both pointed out that there are 15~30K temperature drop in the narrow gap between the wafer and heater with the pressure of 1~10Torr at the outlet of the chamber, the mass flow of 5000sccm at the inlet, and the fixed temperature of 673K within the heater. The lower the pressure was, the greater the differences were, and it presented a negative exponential relation. In addition, this paper predicted the response of the wafer surface temperature to the change of the narrow gap height and chamber pressure via numerical calculation model. The results showed a negative linear relationship between the wafer top surface temperature and the narrow gap height. When the narrow gap height was changed in the range of 0.15~2mm and chamber pressure of 1~10Torr, the temperature of wafer will drop 0.5~5.5K.

Wafer temperature control method and equipment

Feedback Control System of Wafer Temperature for Advanced Plasma Processing and its Application to Organic Film Etching

Modeling Of Two-Dimensional Dynamic Temperature Distribution Of A Lpcvd Process And Control Design By Mpc

Modeling of Heat Transport and Wafer Heating Effects during Plasma Etching

Wafer heating apparatus

Wafer heating device and the wafer heating method

Controlling gate-CD uniformity by means of a CD prediction model and wafer-temperature distribution control

Analysis of the Effect of Heating Control Conditions on Temperature Distribution in a Wafer During Rapid Thermal Processing With Lamp Heaters

Of the semiconductor wafer temperature control device and the control method

Temperature Precise Control in Hot Embossing Device

Finishing of AT-cut quartz crystal wafer with nanometric thickness uniformity by pulse-modulated atmospheric pressure plasma etching

Wafer-to-wafer temperature distribution control in a diffusion furnace

Process kit and wafer temperature effects on dielectric etch rate and uniformity of electrostatic chuck

Study on the Distribution Control of Etching Rate and Critical Dimensions in Microwave Electron Cyclotron Resonance Plasmas for the Next Generation 450 mm Wafer Processing

Effect of Substrate Heating in Thickness Correction of Quartz Crystal Wafer by Plasma Chemical Vaporization Machining

Influence of Configurations of Chamber and Coil on Uniformity of Plasma Distribution for Inductively Coupled Plasma Etcher

Temperature Distribution and Deposition Rate on Semiconductor Wafers in Low-Pressure CVD Equipment Processing Two Wafers

Effect of Internal Structure of a Batch-Processing Wet-Etch Reactor on Fluid Flow and Heat Transfer

Silicon Wafer Etching by Transmitted Electron‐Beam‐Enhanced Plasma

“SumiTune” High-Precision Temperature Distribution Control System for Single-Wafer Film Deposition Equipment

Analysis and Modeling of Wafer Thermal Transfer in a PECVD Reactor