Abstract:The temperature distribution in the reactor, especially on the surface of the wafer, is the important factors influencing the chemical reaction in CVD and PECVD process. This paper focused on a typical cylindrical PECVD reactor carrying with a wafer, and established the combination calculation model, which divided the chamber system into two calculation domains according to the rarefied degree of the gases. A one-dimensional thermal model was developed to calculate the temperature profiles in the narrow gap between the wafer and the heater, considering the heat conduction, radiation and thermal accommodation phenomenon between the gas and the surfaces in low pressure conditions; a two-dimensional axisymmetric model was applied to calculate the temperature profiles in the chamber above the wafer, considering the heat conduction, radiation and mass transfer. We verified the validity of the model through the experimental measurement in different pressure with the aluminum matrix pedestal and the one without. The experiment and numerical calculation both pointed out that there are 15~30K temperature drop in the narrow gap between the wafer and heater with the pressure of 1~10Torr at the outlet of the chamber, the mass flow of 5000sccm at the inlet, and the fixed temperature of 673K within the heater. The lower the pressure was, the greater the differences were, and it presented a negative exponential relation. In addition, this paper predicted the response of the wafer surface temperature to the change of the narrow gap height and chamber pressure via numerical calculation model. The results showed a negative linear relationship between the wafer top surface temperature and the narrow gap height. When the narrow gap height was changed in the range of 0.15~2mm and chamber pressure of 1~10Torr, the temperature of wafer will drop 0.5~5.5K.

Controlling gate-CD uniformity by means of a CD prediction model and wafer-temperature distribution control

Modeling Of Two-Dimensional Dynamic Temperature Distribution Of A Lpcvd Process And Control Design By Mpc

Temperature Uniformity Control in MOCVD Based on Modeling and Optimization

Wafer-to-wafer temperature distribution control in a diffusion furnace

Critical dimension and real-time temperature control for warped wafers

Modelling and Controlling of Critical Dimension in Semiconductor Manufacturing

“SumiTune” High-Precision Temperature Distribution Control System for Single-Wafer Film Deposition Equipment

Study on the Distribution Control of Etching Rate and Critical Dimensions in Microwave Electron Cyclotron Resonance Plasmas for the Next Generation 450 mm Wafer Processing

Feedback Control System of Wafer Temperature for Advanced Plasma Processing and its Application to Organic Film Etching

Machine learning aided process control: critical dimension uniformity control of etching process in 1z nm DRAM

Wafer temperature control method and equipment

Model Predictive Temperature Control of a Distribution System for Chemicals

Effect of Internal Structure of a Batch-Processing Wet-Etch Reactor on Fluid Flow and Heat Transfer

Generalized Predictive Control of Temperature on an Atomic Layer Deposition Reactor

Analysis of the Effect of Heating Control Conditions on Temperature Distribution in a Wafer During Rapid Thermal Processing With Lamp Heaters

Simulation of Flow and Thermal Field in a PECVD Reaction Chamber

A Metal Gate Height Variation Control Method by the Metal Gate Etch at the FinFET Technology

High K Metal Gate Aluminum Cmp Challenges and Solutions

Analysis and Modeling of Wafer Thermal Transfer in a PECVD Reactor

Temperature Distribution and Deposition Rate on Semiconductor Wafers in Low-Pressure CVD Equipment Processing Two Wafers

(Digital Presentation) Uniformity and Profile Improvement of Fin Etching Process at Wafer Extreme Edge for Finfet Mass Production