Abstract:The temperature distribution in the reactor, especially on the surface of the wafer, is the important factors influencing the chemical reaction in CVD and PECVD process. This paper focused on a typical cylindrical PECVD reactor carrying with a wafer, and established the combination calculation model, which divided the chamber system into two calculation domains according to the rarefied degree of the gases. A one-dimensional thermal model was developed to calculate the temperature profiles in the narrow gap between the wafer and the heater, considering the heat conduction, radiation and thermal accommodation phenomenon between the gas and the surfaces in low pressure conditions; a two-dimensional axisymmetric model was applied to calculate the temperature profiles in the chamber above the wafer, considering the heat conduction, radiation and mass transfer. We verified the validity of the model through the experimental measurement in different pressure with the aluminum matrix pedestal and the one without. The experiment and numerical calculation both pointed out that there are 15~30K temperature drop in the narrow gap between the wafer and heater with the pressure of 1~10Torr at the outlet of the chamber, the mass flow of 5000sccm at the inlet, and the fixed temperature of 673K within the heater. The lower the pressure was, the greater the differences were, and it presented a negative exponential relation. In addition, this paper predicted the response of the wafer surface temperature to the change of the narrow gap height and chamber pressure via numerical calculation model. The results showed a negative linear relationship between the wafer top surface temperature and the narrow gap height. When the narrow gap height was changed in the range of 0.15~2mm and chamber pressure of 1~10Torr, the temperature of wafer will drop 0.5~5.5K.

Temperature Distribution and Deposition Rate on Semiconductor Wafers in Low-Pressure CVD Equipment Processing Two Wafers

Modeling Of Two-Dimensional Dynamic Temperature Distribution Of A Lpcvd Process And Control Design By Mpc

Simulation of temperature profile and design of heat transfer structure for reactor of film growth on Si-wafer

Analysis of Temperature and Gas Flow Distribution in Chamber with Wafer Batch

Temperature measurement of wafers with varying multilayer structures during rapid thermal annealing

Wafer-to-wafer temperature distribution control in a diffusion furnace

Analysis and Modeling of Wafer Thermal Transfer in a PECVD Reactor

Scanning Infrared Microscopy Study of Thermal Processing Induced Defects in Low Resistivity Si Wafers

Temperature distribution in semiconductor wafers heated in a vertical diffusion furnace

Simulation of Flow and Thermal Field in a PECVD Reaction Chamber

“SumiTune” High-Precision Temperature Distribution Control System for Single-Wafer Film Deposition Equipment

Silicide Formation with Tungsten Deposited from W-LPCVD; the Role of Back Surface Conditions

300mm Cold-Wall UHV/CVD Reactor for Low-Temperature Epitaxial (100) Silicon

Analysis of Transition Regime Flows in Low Pressure Chemical Vapor Deposition Reactors Using the Direct Simulation Monte Carlo Method

Feedback Control System of Wafer Temperature for Advanced Plasma Processing and its Application to Organic Film Etching

Control of crystalline volume fraction of μC-Si thin film using 40.68 MHz PECVD system for solar cell application

Measurement and Calibration of Substrate Surface Temperature in Hot Filament Chemical Vapor Deposition

High-Rate Deposition of Microcrystalline Silicon Thin Film by Multi-Step Method

Thermal uniformity of 12-in silicon wafer in linearly ramped-temperature transient rapid thermal processing

Low Temperature Silicon Epitaxy in a Single-Wafer RTP Reactor with Microwave Heating

Temperature Control During Chemical Vapor Deposition of Polycrystalline Silicon with Substrate Heating by Microwaves