Abstract:<p>Modern electronic devices with high heat flux increasingly exceed the capability of thermal management method. Two-phase thermal dissipation devices such as vapor chambers offer effective method for high heat flux cooling. Various new structural designs of vapor chambers are used as effective thermal control methods for high heat flux devices. However, the optimization criteria for the capillary wick structures are different. The combinations between the structural surface parameters and pore size of the capillary wick are different, while their influence on the heat transfer performance need to be studied. In this work, it is reported that the fabrication and thermal performance of vapor chambers with multi-layer sintered wicks and multi-artery wick design for liquid supply. We numerically and experimentally characterize the two types of sintered multi-artery wick for replenishing liquid and escaping vapor effectively with high heat flux. Three kinds of combinations of different copper particle sizes were applied to the sintered wicks in order to balance the liquid collecting rate and flow resistance. The copper particles of large particle size (60 μm /100 μm /150 μm) in the upper layer wick and copper particles of small particle size (30 μm /50 μm /100 μm) the lower layer wick were applied in the vapor chambers. In the present study, as an evaluation criteria for capillary wick designs, the relationship between surface porosity, surface area and critical heat flux was analyzed to obtain the experimental optimization of structural design and pore size combination as 50/100 μm. It was found that with similar multi-artery structure wicks, higher surface area porosity can effectively increase the critical heat flux of the vapor chambers. Judging from the experiment results, the minimum through-plane direction heat transfer resistance of the vapor chamber is 0.1426 K/W, the minimum in-plane direction heat transfer resistance is 0.016 K/W, while the critical heat flux of the vapor chamber is 262 W/cm<sup>2</sup>.</p>

Analysis of Temperature and Gas Flow Distribution in Chamber with Wafer Batch

Modeling Of Two-Dimensional Dynamic Temperature Distribution Of A Lpcvd Process And Control Design By Mpc

Simulation of Flow and Thermal Field in a PECVD Reaction Chamber

Analysis and Modeling of Wafer Thermal Transfer in a PECVD Reactor

Finite Element Analysis for NEG coated vacuum chamber based on ANSYS Workbench

Simulation of temperature profile and design of heat transfer structure for reactor of film growth on Si-wafer

Temperature Distribution and Deposition Rate on Semiconductor Wafers in Low-Pressure CVD Equipment Processing Two Wafers

Analysis of Transition Regime Flows in Low Pressure Chemical Vapor Deposition Reactors Using the Direct Simulation Monte Carlo Method

Optimization of Inlets and Outlets of an ALD Chamber with Radiant Heating

Thermal Analysis on Active Heat Dissipation Design with Embedded Flow Channels for Flexible Electronic Devices

Enhanced temperature uniformity of electrostatic chuck: ceramic surface contact ratio and backside gas pressure

Experimental Investigation on the Thermal Performance of a Large-Size Aluminum Vapor Chamber for Multi-Point Heat Sources

Wafer-to-wafer temperature distribution control in a diffusion furnace

Data-Driven Analysis of High-Temperature Fluorocarbon Plasma for Semiconductor Processing

Thermal design aspects for improving temperature homogeneity of silicon wafer during thermal processing in microlithography

Numerical Investigation of Wafer Drying Induced by the Thermal Marangoni Effect

Vapor chamber with two-layer liquid supply evaporator wick for high-heat-flux devices

Direct-simulation Monte Carlo modeling of reactor-scale gas-dynamic phenomena in a multiwafer atomic-layer deposition batch reactor

Study of temperature distributions in wafer exposure process

Numerical Analysis of the Transport Phenomena in MOCVD Process

Design and Flow Simulation on a Variable Structure Plasma Reaction Chamber