Abstract:The temperature distribution in the reactor, especially on the surface of the wafer, is the important factors influencing the chemical reaction in CVD and PECVD process. This paper focused on a typical cylindrical PECVD reactor carrying with a wafer, and established the combination calculation model, which divided the chamber system into two calculation domains according to the rarefied degree of the gases. A one-dimensional thermal model was developed to calculate the temperature profiles in the narrow gap between the wafer and the heater, considering the heat conduction, radiation and thermal accommodation phenomenon between the gas and the surfaces in low pressure conditions; a two-dimensional axisymmetric model was applied to calculate the temperature profiles in the chamber above the wafer, considering the heat conduction, radiation and mass transfer. We verified the validity of the model through the experimental measurement in different pressure with the aluminum matrix pedestal and the one without. The experiment and numerical calculation both pointed out that there are 15~30K temperature drop in the narrow gap between the wafer and heater with the pressure of 1~10Torr at the outlet of the chamber, the mass flow of 5000sccm at the inlet, and the fixed temperature of 673K within the heater. The lower the pressure was, the greater the differences were, and it presented a negative exponential relation. In addition, this paper predicted the response of the wafer surface temperature to the change of the narrow gap height and chamber pressure via numerical calculation model. The results showed a negative linear relationship between the wafer top surface temperature and the narrow gap height. When the narrow gap height was changed in the range of 0.15~2mm and chamber pressure of 1~10Torr, the temperature of wafer will drop 0.5~5.5K.

Enhanced temperature uniformity of electrostatic chuck: ceramic surface contact ratio and backside gas pressure

Evaluation of surface temperature uniformity of multi-zone ceramic heaters with embedded cooling channels for electrostatic chuck

Process kit and wafer temperature effects on dielectric etch rate and uniformity of electrostatic chuck

Implementation Of Temperature Dependent Contact Resistance Model For The Analysis Of Deep Submicron Devices Under Esd

Critical Comparison of Electrostatic Effects on Hydrodynamics and Heat Transfer in a Bubbling Fluidized Bed with a Central Jet

Numerical evaluation on surface temperature uniformity of multi-zone and single-zone ceramic heaters with the electrostatic chuck

Finite Element Analysis on Factors Influencing the Clamping Force in an Electrostatic Chuck

Simulation of Flow and Thermal Field in a PECVD Reaction Chamber

Modeling of Heat Transport and Wafer Heating Effects during Plasma Etching

Analysis and Modeling of Wafer Thermal Transfer in a PECVD Reactor

Experimental and Numerical Simulation Study on Uniformity of Temperature and Flow Field in an Advanced Packaging Electroplating Cell

Influence of Configurations of Chamber and Coil on Uniformity of Plasma Distribution for Inductively Coupled Plasma Etcher

Analysis of Temperature and Gas Flow Distribution in Chamber with Wafer Batch

Simulation of temperature profile and design of heat transfer structure for reactor of film growth on Si-wafer

Experimental study on nanofludic heat pipe hot chuck plate in semiconductor wafer baking process

Study of temperature distributions in wafer exposure process

Characterization of an Etch Profile at a Wafer Edge in Capacitively Coupled Plasma

Thermal design aspects for improving temperature homogeneity of silicon wafer during thermal processing in microlithography

Computational Study of Chemical Uniformity Impacts on Electrodeposition

(Digital Presentation) Uniformity and Profile Improvement of Fin Etching Process at Wafer Extreme Edge for Finfet Mass Production

Two-Dimensional Discharge Simulation of Inductively Coupled Plasma Etcher