Abstract:Atmospheric-pressure (AP) plasma sources have attracted researchers in many engineering fields, due to its low cost and easy handling. The AP plasma technique has been successfully applied on the surface figuring and texturing of Si, fused silica, RS-SiC, and SiC, etc. However, these studies focus more on better control for surface figuring of the substrate. The understanding of how the Si surface roughening or smoothing is occurred during the AP plasma etching using He-based CF4 mixture gas has seldom been reported. The present study starts from a parametric study of O2 addition concentration to He-based CF4 plasma. A groove is initially etched on a single-crystal silicon wafer by the CCP-type parallel-plate plasma etcher, to study the etching rate, surface morphology, material removal characteristics, and surface roughness evolution after the plasma etched removal. It is revealed that the material removal with a typical profile is achieved without introducing further damage. At the same time, the surface finish and surface integrity were enhanced by the AP plasma. The underlying mechanism of the process was investigated. Additionally, the optimized gas composition is then applied to the larger area etching by the computer-controlled scanning with different feed rates. Based on the experimental results, the surface evolution during the plasma etching process is revealed in detail. The surface removal profile also demonstrates that this method can provide an alternative way to achieve damage-free material removal for a larger area substrate by the duplicating of the typical removal profile with different etching path.

Study on the Distribution Control of Etching Rate and Critical Dimensions in Microwave Electron Cyclotron Resonance Plasmas for the Next Generation 450 mm Wafer Processing

Isotropic Etch for SiO2 Microcantilever Release with ICP System

Across wafer etch rate uniformity in a high density plasma reactor: Experiment and modeling

Optimization of an electron cyclotron resonance etch process using full wafer charge coupled device interferometry

Boundary effect on mode transformation in an electron cyclotron resonance etching reactor

Pulse‐time‐modulated electron cyclotron resonance plasma etching with low radio‐frequency substrate bias

Experimental study on characteristics of ECR microwave plasma

Experimental Study of SiO2 Sputter Etching Process in 13.56 MHz Rf-Biased Inductively Coupled Plasma

A New Microplasma Reactor for Scanning Plasma Etching

Feedback Control System of Wafer Temperature for Advanced Plasma Processing and its Application to Organic Film Etching

Simultaneous Diagnostics of Electron Density and Temperature in Micoplasma Reactor for Scanning Plasma Etching

Study on the Key Parameters in Etching of Fused Silica Using Atmospheric Inductively Coupled Plasma

Design and fabrication of the microplasma reactor for maskless scanning plasma etching

Silicon Wafer Etching by Transmitted Electron‐Beam‐Enhanced Plasma

A study on the etching characteristics of atmospheric pressure plasma for single-crystal silicon wafer

Two-Dimensional Discharge Simulation of Inductively Coupled Plasma Etcher

Process kit and wafer temperature effects on dielectric etch rate and uniformity of electrostatic chuck

Design and fabrication of microcantilever probe integrated with microplasma reactor for maskless scanning plasma etching

Large-Area Surface Treatment of Monocrystalline Silicon by ECR Plasmas at Low Temperature

Design and Experiments of Microplasma Reactor for Scanning Plasma Etching

Effects of Chamber Wall Conditions on Cl Concentration and Si Etch Rate Uniformity in Plasma Etching Reactors