Abstract:Microfabrication technology with quartz crystals is gaining importance as the miniaturization of quartz MEMS devices is essential to ensure the development of portable and wearable electronics. However, until now, there have been no reports of dimension compensation for quartz device fabrication. Therefore, this paper studied the wet etching process of Z-cut quartz crystal substrates for making deep trench patterns using Au/Cr metal hard masks and proposed the first quartz fabrication dimension compensation strategy. The size effect of various sizes of hard mask patterns on the undercut developed in wet etching was experimentally investigated. Quartz wafers masked with initial vias ranging from 3 μm to 80 μm in width were etched in a buffered oxide etch solution (BOE, HF:NH4F = 3:2) at 80 °C for prolonged etching (>95 min). It was found that a larger hard mask width resulted in a smaller undercut, and a 30 μm difference in hard mask width would result in a 17.2% increase in undercut. In particular, the undercuts were mainly formed in the first 5 min of etching with a relatively high etching rate of 0.7 μm/min (max). Then, the etching rate decreased rapidly to 27%. Furthermore, based on the etching width compensation and etching position compensation, new solutions were proposed for quartz crystal device fabrication. And these two kinds of compensation solutions were used in the fabrication of an ultra-small quartz crystal tuning fork with a resonant frequency of 32.768 kHz. With these approaches, the actual etched size of critical parts of the device only deviated from the designed size by 0.7%. And the pattern position symmetry of the secondary lithography etching process was improved by 96.3% compared to the uncompensated one. It demonstrated significant potential for improving the fabrication accuracy of quartz crystal devices.

Effect of Substrate Heating in Thickness Correction of Quartz Crystal Wafer by Plasma Chemical Vaporization Machining

Finishing of AT-cut quartz crystal wafer with nanometric thickness uniformity by pulse-modulated atmospheric pressure plasma etching

Highly efficient damage-free correction of thickness distribution of quartz crystal wafers by atmospheric pressure plasma etching

Research on Removal Characteristic of the Optical Quartz with Atmospheric Pressure Plasma Jet

Study of Form Control Algorithm in Atmospheric Pressure Plasma Processing

Research on Trimming Frequency-Increasing Technology for Quartz Crystal Resonator Using Laser Etching

Size-Effect-Based Dimension Compensations in Wet Etching for Micromachined Quartz Crystal Microstructures

Research on a Compensation Correction Algorithm for the Removal Function of Atmospheric-Pressure Plasma Processing

Infrared Pulsed Picosecond Laser-Induced Plasma-Assisted Ablation of Micro-textures on Quartz Surface

Deep Reactive Ion Etching of Z-Cut Alpha Quartz for MEMS Resonant Devices Fabrication

SACE Scanning Process Assisted with Ultrasonic Vibration on Quartz Glass

A New Method Used to Control the Structure of High Rate Microcrystalline Silicon Thin Films

Surface Quality Improvement of Atmospheric Pressure Plasma Polishing (appp) in Machining of Silicon Ultra-Smooth Surfaces

High-precision finishing method for narrow-groove channel-cut crystal x-ray monochromator using plasma chemical vaporization machining with wire electrode

Research on a Micro-Processing Technology for Fabricating Complex Structures in Single-Crystal Quartz

Surface Modification of Silicon Carbide Wafers Using Atmospheric Plasma Etching: Effects of Processing Parameters

Form Control In Atmospheric Pressure Plasma Processing Of Ground Fused Silica

Atmospheric Pressure Plasma Processing of Fused Silica in Different Discharge Modes

Thermal Modelling for Conformal Polishing in Inductively Coupled Atmospheric Pressure Plasma Processing

Liquid-Assisted Femtosecond Laser Precision-Machining of Silica.

Etching Quartz with Inductively Coupled Plasma Etching Equipment