Abstract:Limit pressures and corresponding maximum local membrane Stress Concentration Factors (SCF) are assessed for two orthogonally intersecting thin-walled cylindrical shells subjected to internal pressure. The limit pressures of 81 models with parameters ρ=d/D≤0.8, D/T≥10, d/t≥10, λ=d/DT≤8 and d/D≤t/T≤2 are calculated using inelastic analyses by the 3D finite element method (3D FEM) in which the material is elastic-perfectly plastic. The plastic collapse pressures obtained by 3D FEM are in good agreement with test results presented by previous authors. The local membrane SCF at the intersections of two cylindrical shells subjected to the limit pressure load is calculated by elastic thin shell theoretical solutions presented by Xue and Hwang. The local membrane SCF decreases significantly as t/T increases, and decreases little as d/DT decreases when D/T is fixed. The local membrane SCF increases significantly as D/T increases, and varies little as d/DT increases when t/T is constant. The local membrane stress criterion km≤2.2 for reinforcement design of openings in a cylindrical pressure vessel subjected to internal pressure can be accepted generally except for a few cases of large thickness ratio t/T, and small opening ratio ρ.

Limit analysis of equal-diameter piping branch junctions with local wall-thinning under internal pressure

Limit Analysis for Piping Branch Junctions with Local Wall-Thinning under Pressure

PLASTIC LIMIT LOAD ANALYSIS OF T-JUNCTIONS OF PIPING WITH LOCAL WALL-THINNINGS UNDER OUT-OF-PLANE MOMENT

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

FINITE ELEMENT ANALYSIS OF PLASTIC LIMIT LOADS OF LOCALLY THINNED ELBOWS UNDER INTERNAL PRESSURE AND IN-PLANE BENDING MOMENT

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

Numerical Limit Load Analysis of Pipelines with Local Wall-Thinning

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Safety analysis of pressure piping containing incomplete penetration under combined loads

Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment

Finite element analysis of the limit load of pipe bend with local wall-thinning defect under complex loads

Elastic Buckling of Cylindrical Pipe Linings with Variable Thickness Encased in Rigid Host Pipes

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

An Analysis on the Safety Performance of the Combined Fittings of Straight Tees and Long Radius Elbows

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Plastic Limit Analysis of Defective Piping Systems

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings