Abstract:In this paper, we first introduce the iterative method of the modified elastic compensation method (KtECM) proposed by the authors, which can be used for limit load analysis of complex structures. Then, plastic limit load of thin-walled tee joint containing corner cracks under internal pressure is computed by using the KtECM, the elastic compensation method (ECM), and the elastic-plastic analysis method (EPAM). During computations, we consider three different possible crack propagation modes including the crack growing along the run pipe, the crack growing along the branch pipe, the crack growing in the direction of through the weld zone. These computation results show that the KtECM can provide good estimations of plastic limit loads for cracked structures. The error between the K,ECM solution and the elastic-plastic solution for most computations is within 10%. For tee joint, the crack growing along the run pipe is more dangerous than the crack growing along the branch pipe and when the crack extends to above 68 percent of the welding corner height, the crack growing in the direction of through the weld zone is the most dangerous mode. Finally, we establish the relationship between the crack length and the plastic limit load for the tee joint in this paper by quadratic polynomial and piecewise polynomial function.

PLASTIC LIMIT LOAD ANALYSIS OF T-JUNCTIONS OF PIPING WITH LOCAL WALL-THINNINGS UNDER OUT-OF-PLANE MOMENT

Limit analysis of equal-diameter piping branch junctions with local wall-thinning under internal pressure

FINITE ELEMENT ANALYSIS OF PLASTIC LIMIT LOADS OF LOCALLY THINNED ELBOWS UNDER INTERNAL PRESSURE AND IN-PLANE BENDING MOMENT

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment

Safety analysis of pressure piping containing incomplete penetration under combined loads

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

Limit Analysis for Piping Branch Junctions with Local Wall-Thinning under Pressure

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Plastic Limit Load Analysis of Tee Joint Containing Corner Cracks

Numerical Limit Load Analysis of Pipelines with Local Wall-Thinning

Plastic Limit Analysis of Defective Piping Systems

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Finite element analysis of the limit load of pipe bend with local wall-thinning defect under complex loads

Plastic Limit Load Analysis of Defective Pipelines

Elastic Buckling of Cylindrical Pipe Linings with Variable Thickness Encased in Rigid Host Pipes

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures