Abstract:A new theoretical model was proposed to calculate the burst pressure of steel strip reinforced flexible composite pipes (steel strip PSP) based on the thin wall cylindrical shell theory and the squeeze pressure expression between layers was derived. The radial displacement discontinuity of pipe wall in pipe-end fitting joint area takes in account in this model which could result in Stress Concentration Effect (SCE) in reinforcement layers. The SCE is caused by swaging end fitting clamped tightly at the end of the pipe. The result of the hoop strain in the joint area calculated by this model is greater than the one calculated by the classic elastic model, which leads to relative conservative burst strength of the pipe. The hoop stress variation via internal pressure on innermost reinforcement layer is introduced to predict the burst strength of the pipe. As the stress in the joint area reaches its ultimate strength, the strain on the same layer in the point far away from this area (x?8) is extracted and the corresponding internal pressure is obtained as the burst strength of the pipe. The calculated data from two models were compared with the experiment results and the proposed new model showed better accuracy than the classic elastic model. Final additional parametric studies were conducted, while the effect of the pipe diameter, the winding angle, the number and thickness of the reinforcement layer on the burst strength of the pipe were studied. Useful conclusions were drawn for the design and application of the steel strip PSP in offshore engineering.

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Estimation of burst pressure of pipeline using twin-shear stress yield criterion

Effect of the Y/T on the Burst Pressure for Corroded Pipelines with High Strength

BURST FAILURE ANALYSIS OF PLASTIC ANISOTROPIC THICK-WALLED CYLINDRICAL VESSELS SUBJECTED TO COMBINED PRESSURES

A study of the ultimate compressive strain of local buckling in strain-based design of pipelines

Unified Plastic Limit Solution for Thick-Walled Cylinder with Size Effect

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Double Circular Arc Model Based on Average Shear Stress Yield Criterion and Its Application in the Corroded Pipe Burst

The Failure Window Method and Its Application in Pipeline Burst

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Integrity Assessment of the Pipelines Containing an Isolated Corrosion Pit

Safety analysis of pressure piping containing incomplete penetration under combined loads

Failure pressure analysis of corroded moderate-to-high strength pipelines

On Collapse Failure Analysis Of Subsea Corroded Sandwich Pipelines Under External Pressure

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

On the analysis of burst capacity of steel strip reinforced flexible pipe with swaging endfitting

Theoretical Modeling Of Steel Strip Reinforced Flexible Pipe With Swaging End Fitting By Taking Into Account Stress Concentration Effect