Abstract:In this paper, a high-resistivity silicon (HR-Si) interposer integrated with through-silicon via (TSV) electrically grounded coplanar waveguide (CPW) line is presented for 2.5-D/3-D heterogeneous integration of radio frequency (RF) microelectronics devices. In addition, design of TSV interconnection composed of two coaxial ladder-hollow-annular Cu (copper) TSVs of different diameters is utilized to maintain a sufficient freedom for strict standard cleaning to avoid Si resistivity degradation. The formation of the coaxial ladder TSV structure is more beneficial to the subsequent plating process because it reduces the aspect ratio of TSV vias. Hollow-annular Cu TSV is manufactured in order to reduce the problem of mismatch in coefficient of thermal expansion among TSV's constituent materials. A layer of Au (aurum) film is utilized to passivate the exposed Cu surface of Si interposer. Au is widely used in III-V groups' devices because of the good compatibility with photonic integrated circuits, conductivity, and corrosion resistance. HR-Si interposer with TSV grounded CPW line and test structure is fabricated and characterized. With the monitoring test results, it can be found that it changes little in the resistivity of Si substrate, though the whole process, which is a basic requirement for RF performance. RF property test results show that the insertion loss is about -0.20 dB/mm at 10 GHz for the presented TSV grounded CPW line and -0.02 dB per TSV. These test results are better than the traditional design. To verify its applicability to 2.5-D/3-D heterogeneous integration, RF microelectronics die is assembled on TSV interposer and tested, and the test results prove that it works properly.

Fabrication and characterization of a low-cost interposer with an intact insulation layer and ultra-low TSV leakage current

Fabrication, Characterization, and Simulation of a Low-Cost TSV Integration Without Front-Side CMP Process

Double-Shielded Interposer with Highly Doped Layers for High-Speed Signal Propagation

Fabrication and Characterization of a Low Parasitic Capacitance and Low-Stress Si Interposer for 2.5-D Integration

Interposer Fabrication with Annular Copper Tsv and Multi-Layered Redistribution Layer

An ultra-deep TSV technique enabled by the dual catalysis-based electroless plating of combined barrier and seed layers

A Shielding Structure for Crosstalk Reduction in Silicon Interposer

Fabrication and Characterization of Low Stress Si Interposer with Air-Gapped Si Interconnection for Hermetical System-in-Package

Copper electroplating technique for efficient manufacturing of low-cost silicon interposers

Fabrication of Microchannel Embedded Tsv Interposer and Its Influence on Tsv'S Electrical Parameters

Fabrication and RF Property Evaluation of High-Resistivity Si Interposer for 2.5-D/3-D Heterogeneous Integration of RF Devices

Fabrication and Characterization of Annular Copper Through-Silicon Via for Passive Interposer Applications

Fabrication and Characterization of Fine Pitch TSV Integration with Self-Aligned Backside Insulation Layer Opening.

Assembly and Testing of Thermal Test Chip on Silicon Interposer with Through Silicon Via

Crosstalk Reduction in TSV Arrays with Direct Ohmic Contact Between Metal and Silicon-Substrate

Design and fabrication of a TSV interposer for SRAM integration

Design, Fabrication and Characterization of a Novel TSV Interposer Integrated Inductor for RF Applications

A Wet Process to Fabricate Silicon Oxide Layer for Through-Silicon-via Insulator Application

Development of a Polyimide/SiC-Whisker/Nano-Particles Composite with High Thermal Conductivity and Low Coefficient of Thermal Expansion As Dielectric Layer for Interposer Application

Implementation of Air-Gap Through-Silicon-Vias (TSVs) Using Sacrificial Technology

Development of Ultra-Low Capacitance Through-Silicon-vias (tsvs) with Air-Gap Liner