Abstract:The concept of 3D capacitor embedded in TSV has been proposed recently to achieve ultrahigh capacitance density (up to 5,621.8 nF/mm2). This paper aims to investigate the effects of trench sidewall roughness and electrode deposition method on the dielectric quality of the 3D capacitor embedded in TSV. The test vehicles of 3D embedded capacitors were designed and fabricated with variations, which were the combinations of: (a) two options of trench sidewall roughness (30 and 290 nm) and (b) three options of electrode deposition methods (sputtering, ALD with air exposure, and ALD without air exposure). For test vehicles with different sidewall roughness but the same electrode deposition method, insignificant change of the leakage current density and dielectric strength can be observed in their J-E plots. Despite thicker dielectric layer, the leakage current density of sputtering test vehicles becomes higher than their ALD counterparts at bias greater than 3.5 MV/cm and dielectric strength ends up lower $(\sim 7.8\ \text{vs}. > 9\ \mathrm{MV}/\text{cm})$. Therefore, sputtering is found not suitable for the fabrication of high performance 3D embedded capacitor. Besides, the elimination of air exposure during the process of ALD test vehicles helps suppress the leakage current density when the bias is greater than 4 MV/cm: e.g. it drops from $2.78\times 10^{-2}$ to $4.83\times 10^{-5}$ A/cm2 at 8 MV/cm. Moreover, C-V characterization results suggest that the dielectric composition and the total amount of trapped charges become instable for the test vehicles with rough sidewall (290 nm), whereas they are consistent for the test vehicles with smooth sidewall (30 nm). These findings can provide valuable information for performance optimization and long-term reliability assessment of 3D capacitor embedded in TSV.

Development of Ultra-Low Capacitance Through-Silicon-vias (tsvs) with Air-Gap Liner

Ultralow-Capacitance Through-Silicon Vias with Annular Air-Gap Insulation Layers

Low-Capacitance Through-Silicon-Vias with Combined Air/Sio2 Liners

Low Capacitance Through-Silicon-Vias with Uniform Benzocyclobutene Insulation Layers

Implementation of Air-Gap Through-Silicon-Vias (TSVs) Using Sacrificial Technology

Air-gap/SiO<inf>2</inf> liner TSVs with improved electrical performance

High aspect ratio and low capacitance through-silicon-vias (TSVs) with polymer insulation layers

Thermal and electrical tests of air-gap TSV

Thermal Reliability Tests of Air-Gap TSVs with Combined Air-SiO2Liners

Electrothermal modelling of through silicon via (TSV) interconnects

Thermal and Electrical Reliability Tests of Air-Gap Through-Silicon Vias

Electrothermal Effects in High Density Through Silicon Via (tsv) Arrays

Multiphysics Characterization of Polymer‐filled Through‐silicon Vias (pf‐tsvs) for Three‐dimensional Integration

Thermal and Electrical Properties of BCB-Liner Through-Silicon Vias

High-Frequency Characterization of Through-Silicon-Vias With Benzocyclobutene Liners

Dielectric Quality of 3D Capacitor Embedded in Through-Silicon Via (TSV)

Reliability of Through-Silicon-vias (tsvs) with Benzocyclobutene Liners.

An ultra-deep TSV technique enabled by the dual catalysis-based electroless plating of combined barrier and seed layers

A Novel Manufacturing Scheme for Tsvs with Porous Polymer Insulation Liners

Electrical Characterization of Sidewall Insulation Layer of TSV

Design, Fabrication and Characterization of TSV Interposer Integrated 3D Capacitor for SIP Applications