Abstract:The concept of 3D capacitor embedded in TSV has been proposed recently to achieve ultrahigh capacitance density (up to 5,621.8 nF/mm2). This paper aims to investigate the effects of trench sidewall roughness and electrode deposition method on the dielectric quality of the 3D capacitor embedded in TSV. The test vehicles of 3D embedded capacitors were designed and fabricated with variations, which were the combinations of: (a) two options of trench sidewall roughness (30 and 290 nm) and (b) three options of electrode deposition methods (sputtering, ALD with air exposure, and ALD without air exposure). For test vehicles with different sidewall roughness but the same electrode deposition method, insignificant change of the leakage current density and dielectric strength can be observed in their J-E plots. Despite thicker dielectric layer, the leakage current density of sputtering test vehicles becomes higher than their ALD counterparts at bias greater than 3.5 MV/cm and dielectric strength ends up lower $(\sim 7.8\ \text{vs}. > 9\ \mathrm{MV}/\text{cm})$. Therefore, sputtering is found not suitable for the fabrication of high performance 3D embedded capacitor. Besides, the elimination of air exposure during the process of ALD test vehicles helps suppress the leakage current density when the bias is greater than 4 MV/cm: e.g. it drops from $2.78\times 10^{-2}$ to $4.83\times 10^{-5}$ A/cm2 at 8 MV/cm. Moreover, C-V characterization results suggest that the dielectric composition and the total amount of trapped charges become instable for the test vehicles with rough sidewall (290 nm), whereas they are consistent for the test vehicles with smooth sidewall (30 nm). These findings can provide valuable information for performance optimization and long-term reliability assessment of 3D capacitor embedded in TSV.

Ultralow-Capacitance Through-Silicon Vias with Annular Air-Gap Insulation Layers

Development of Ultra-Low Capacitance Through-Silicon-vias (tsvs) with Air-Gap Liner

Low-Capacitance Through-Silicon-Vias with Combined Air/Sio2 Liners

Low Capacitance Through-Silicon-Vias with Uniform Benzocyclobutene Insulation Layers

Implementation of Air-Gap Through-Silicon-Vias (TSVs) Using Sacrificial Technology

Study on the behaviors of Cu filling in special through-silicon-vias by the simulation of electric field distribution

Wetting Process of Copper Filling in Through Silicon Vias

High aspect ratio and low capacitance through-silicon-vias (TSVs) with polymer insulation layers

Air-gap/SiO<inf>2</inf> liner TSVs with improved electrical performance

Electrical Characterization of Through-Silicon Vias (TSV) with Different Physical Configurations

Thermal and Electrical Reliability Tests of Air-Gap Through-Silicon Vias

Thermal and electrical tests of air-gap TSV

Electrothermal modelling of through silicon via (TSV) interconnects

Novel LC resonant clocking for 3D IC using TSV-inductor and capacitor

Thermal Reliability Tests of Air-Gap TSVs with Combined Air-SiO2Liners

Electrical Characterization of Sidewall Insulation Layer of TSV

Mechanical Reliability Testing of Air-Gap Through-Silicon Vias

Dielectric Quality of 3D Capacitor Embedded in Through-Silicon Via (TSV)

An ultra-deep TSV technique enabled by the dual catalysis-based electroless plating of combined barrier and seed layers

Coaxial Through-Silicon-Vias Using Low-κ SiO2 Insulator

Electrical Characterization of Shielded TSVs With Airgap Isolation for RF/mmWave Applications