Abstract:In this paper, a high-resistivity silicon (HR-Si) interposer integrated with through-silicon via (TSV) electrically grounded coplanar waveguide (CPW) line is presented for 2.5-D/3-D heterogeneous integration of radio frequency (RF) microelectronics devices. In addition, design of TSV interconnection composed of two coaxial ladder-hollow-annular Cu (copper) TSVs of different diameters is utilized to maintain a sufficient freedom for strict standard cleaning to avoid Si resistivity degradation. The formation of the coaxial ladder TSV structure is more beneficial to the subsequent plating process because it reduces the aspect ratio of TSV vias. Hollow-annular Cu TSV is manufactured in order to reduce the problem of mismatch in coefficient of thermal expansion among TSV's constituent materials. A layer of Au (aurum) film is utilized to passivate the exposed Cu surface of Si interposer. Au is widely used in III-V groups' devices because of the good compatibility with photonic integrated circuits, conductivity, and corrosion resistance. HR-Si interposer with TSV grounded CPW line and test structure is fabricated and characterized. With the monitoring test results, it can be found that it changes little in the resistivity of Si substrate, though the whole process, which is a basic requirement for RF performance. RF property test results show that the insertion loss is about -0.20 dB/mm at 10 GHz for the presented TSV grounded CPW line and -0.02 dB per TSV. These test results are better than the traditional design. To verify its applicability to 2.5-D/3-D heterogeneous integration, RF microelectronics die is assembled on TSV interposer and tested, and the test results prove that it works properly.

Interposer Fabrication with Annular Copper Tsv and Multi-Layered Redistribution Layer

Influence of Electroplating Current Density on Through Silicon Via Filling

Fabrication and Characterization of Annular Copper Through-Silicon Via for Passive Interposer Applications

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Fabrication, Characterization, and Simulation of a Low-Cost TSV Integration Without Front-Side CMP Process

Copper electroplating technique for efficient manufacturing of low-cost silicon interposers

Simultaneously performing interlayer copper interconnecting and TSV filling in stacked chips at room temperature based on copper electroplating

Double-Shielded Interposer with Highly Doped Layers for High-Speed Signal Propagation

Design and fabrication of a TSV interposer for SRAM integration

Fast copper plating process for TSV fill

A Shielding Structure for Crosstalk Reduction in Silicon Interposer

Copper Filling Process for Small Diameter, High Aspect Ratio Through Silicon Via (Tsv)

Copper-Based TSV: Interposer

Process Development of Thick Si Interposer for 2.5d Integration of Rf Mems Devices

Fabrication of Microchannel Embedded Tsv Interposer and Its Influence on Tsv'S Electrical Parameters

Quality Evaluation and Simulation of Through-Multilayer Tsv Integration Process for Memory Stacking

Performance and reliability study of TGV interposer in 3D integration

Fabrication Process of A Tsv Interposer for Radio Frequency Chip with Integrated Passive Devices

Fabrication and RF Property Evaluation of High-Resistivity Si Interposer for 2.5-D/3-D Heterogeneous Integration of RF Devices

Effect of Copper TSV Annealing on Via Protrusion for TSV Wafer Fabrication

Fabrication Process of A Triple-Layer Stacked Tsv Interposer for Switch Matrix Consisting of Eight Rf Chips