Abstract:3D wafer or chip stacking by through-silicon vias (TSVs) has brought the industry close to a breakthrough. For fabricating TSV structure, a serious challenge is the front side chemical mechanical planarization (CMP) process and especially non-uniformity within 300 mm post-CMP wafers. This paper makes thorough investigation into front side CMP by studying material removal rate (MRR) selectivity and non-uniformity (NU) in TSV and corresponding copper/TEOS layer removal. MRR and NU of different layers were measured under different polishing down force and hydrogen peroxide concentration, and removal rate selectivity was calculated and compared. The results showed that down force should be controlled to achieve a high material removal rate while greatly maintaining NU in a low level. Hydrogen peroxide concentration had a very strong influence on MRR and selectivity of copper/TEOS oxide and directly leads to via dishing situation, which influence the non-uniformity. Subsequently, an ideal combination of process parameters were achieved to obtain a good result in terms of low non-uniformity. This was applied to TSV polishing to verify performance and stability, conducted in a marathon test including TSV/copper/TEOS wafers. In order to facilitate the explanation of TSV removal, the synergistic effect of different layers and removal mechanism on TSV CMP were explained. This conform to the experiments, which is of great value to further research about profile control in the TSV CMP process.

The Study of Backside Tsv Reveal Process by Direct Si/Cu Grinding and Polishing

Effect of leveler on microstructure and stress of electroplated copper for TSV application

Study on the behaviors of Cu filling in special through-silicon-vias by the simulation of electric field distribution

Improvement of a TSV Reveal Process Comprising Direct Si/Cu Grinding and Residual Metal Removal

Development of Cu-less TSV reveal process using Si/Cu grinding, electroless Ni plating, and alkaline etching of Si

TSV CMP process optimization and dishing defect reduction

Non-uniformity and Removal Rate Selectivity Investigations in Through Silicon Via Front Side CMP

Improvement of Via Dishing and Non-Uniformity in TSV Chemical Mechanical Planarization

Opening the Hole of the Backside Silicon and Forming the Alloy Bump For TSVs

CU seed, CMP process development and via resistance extraction in through silicon via technology

A Research Of The Micro-Damage Of The Backside Tsv Heterogeneous Microstructure After Cmp Process With Alkaline Slurry

Copper Chemical Mechanical Polishing and Wafer Thinning with Temporary Bonding for Through Silicon Via Interconnect

A Wet Etching Approach for the Via-Reveal of a Wafer with Through Silicon Vias

A Low Cost and Residue-Free Abrasive-Free Copper Cmp Process with Low Dishing, Erosion and Oxide Loss

An Efficient and High Quality Chemical Mechanical Polishing Method for Copper Surface in 3D TSV Integration

The Effect of Inhibitors on the Electrochemical Deposition of Copper Through-silicon Via and its CMP Process Optimization

Investigate the Microstructure Changes in Cu Through-Silicon Vias (tsvs) under Thermal Process

Fabrication, Characterization, and Simulation of a Low-Cost TSV Integration Without Front-Side CMP Process

Copper electroplating technique for efficient manufacturing of low-cost silicon interposers

3D interconnection process development and integration with low stress TSV

A novel plating bath device for reducing surface copper thickness and improving wafer-scale uniformity