Abstract:This paper reports on a novel in-plane and electrostatically actuated bi-stable radio frequency (RF) microelectromechanical systems (MEMS) switch. A lateral RF MEMS switch designed by the inertial generated timing sequence (IGTS) method is able to latch sequentially by only a single voltage signal. In the switch design, we applied a mass block to one of the two mutually perpendicular cantilevers to achieve an extremely simple bi-stable process. Compared with previous bi-stable RF MEMS switches, the proposed device does not require driving signals with complicated timing sequences to realize latch. Therefore, the hardware complexity of RF systems is reduced, and the driving method becomes easier than before. Thanks to the bi-stable function, the power consumption only generates between the OFF and ON state, resulting in zero static power consumption. The switch was fabricated by silicon-on-glass (SOG) processes with only two lithographic masks. Measured results have shown that the manufactured RF MEMS switch successfully realized the bi-stable function at an operating voltage of 38 V. At 6 GHz, the measured isolation was − 33.18 dB, while the insertion loss was below − 1.9 dB. The presented switch in this paper is dedicated for low power consumption and low hardware redundancy wireless communication systems.

A dielectric-bridge-type MEMS series contact switch for 0-10GHz applications

Realization of A Series Contact Mems Switch with Sion Dielectric Bridge

An Ultra-Broadband Contact-Capacitive RF MEMS Switch for 15-110GHZ Applications

SP4T RF MEMS Switch with Low Actuation Voltage

Design and fabrication of X-band capacitive MEMS switches

Novel Multicontact Radio Frequency Microelectromechanical System Switch in High-Power–handling Applications

Electro-thermally actuated RF MEMS switch for wireless communication.

Design and Fabrication of a Capacitive Series RF MEMS Switch

High-Isolation Contact Switch in Mems Phase Shifter

A Zero Static Power Consumption Bi-Stable RF MEMS Switch Based on Inertial Generated Timing Sequence Method

Scalable Contact-Capacitive MEMS Switches with High Capacitance Ratio for Millimeter-Wave Applications

A Novel 3-resonance Capacitive RF MEMS Switch

Novel Process for Fabrication of RF MEMS Switch with High Mechanical Reliability

Al/Au Composite Membrane Bridge DC-contact Series RF MEMS Switch

Design and Fabrication of a Low Insertion Loss Capacitive RF MEMS Switch with Novel Micro-Structures for Actuation

A High-Linearity SP12T RF MEMS Switch Using Parallel Dual-Cantilevers for 5G and Beyond Applications

Design and Analysis of a Lateral Lateral DC-Contact MEMS RF Switch with High Performance

Design and Fabrication of DC to 30 GHz DC-contact Shunt RF MEMS Switch

A Low-Voltage Lateral MEMS Switch with High RF Performance

High-isolation lateral RF MEMS capacitive switch based on HfO2 dielectric for high frequency applications

Low-voltage Micromachining-Based Scalable Optical Switch