Abstract:This article proposes a three-dimensional heterogenous-integrated (3DHI) switchable bandpass filter bank with two independent wideband filter channels that cover 26-40 GHz and 32.5-40 GHz, respectively. An accurate wafer-level process with a high hollowed ratio of the applied 8-inch high-resistivity-silicon (HR-Si) interposer wafers is presented to form both compact filter channels. Above the interdigital filter patterns fabricated on the bottom interposer wafer, deep cavities are etched in the cap interposer wafer to improve the quality factor of the filter bank. Besides the cavities, the cap interposer wafer is 35% hollow inside, which two bare dies of GaAs single-pole double-throw (SPDT) switches and two thin film resistors are attached to the bottom interposer after the wafer-to-wafer (W2W) bonding. To ensure good out-of-band performance, a 3D EM co-simulation of the switch layout at the chip level and filter patterns at the package level is applied. Measurement results show that the switchable filter bank achieves a high isolation of 50 dB and a competitive shape factor (BW30dB/BW3dB) of about 1.3. In addition, the size of the switchable filter bank is only 7.0 mm x 3.5 mm x 0.6 mm, and the weight is only 0.1 g.

An Ultra-Broadband Contact-Capacitive RF MEMS Switch for 15-110GHZ Applications

Design and fabrication of X-band capacitive MEMS switches

Scalable Contact-Capacitive MEMS Switches with High Capacitance Ratio for Millimeter-Wave Applications

Design of Broadband High-Frequency Multi-Throw RF-MEMS Switches

A dielectric-bridge-type MEMS series contact switch for 0-10GHz applications

Design and Fabrication of a Low Insertion Loss Capacitive RF MEMS Switch with Novel Micro-Structures for Actuation

Design and Fabrication of a Capacitive Series RF MEMS Switch

Novel Multicontact Radio Frequency Microelectromechanical System Switch in High-Power–handling Applications

Electro-thermally actuated RF MEMS switch for wireless communication.

A High-Linearity SP12T RF MEMS Switch Using Parallel Dual-Cantilevers for 5G and Beyond Applications

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

A Novel 3-resonance Capacitive RF MEMS Switch

Study on RF MEMS Switch with Four Parallel Ohm Contacts for Power Handling Enhancement

Multi-contact Radiofrequency Microelectromechanical Systems Switch with Power Divider/combiner Structure for High Power Applications

Design and Fabrication of DC to 30 GHz DC-contact Shunt RF MEMS Switch

Design, optimization and simulation of a low-voltage shunt capacitive RF-MEMS switch

Design and Analysis of a Lateral Lateral DC-Contact MEMS RF Switch with High Performance

Design and Modeling of a Continuously Variable Piezoelectric RF MEMS Switch

High-isolation lateral RF MEMS capacitive switch based on HfO2 dielectric for high frequency applications

Rf Mems Switch and Its Applications

Power Handling Capability Enhanced RF MEMS Switch Using Modified-Width Cantilevers Structure