Abstract:This paper reports on a novel in-plane and electrostatically actuated bi-stable radio frequency (RF) microelectromechanical systems (MEMS) switch. A lateral RF MEMS switch designed by the inertial generated timing sequence (IGTS) method is able to latch sequentially by only a single voltage signal. In the switch design, we applied a mass block to one of the two mutually perpendicular cantilevers to achieve an extremely simple bi-stable process. Compared with previous bi-stable RF MEMS switches, the proposed device does not require driving signals with complicated timing sequences to realize latch. Therefore, the hardware complexity of RF systems is reduced, and the driving method becomes easier than before. Thanks to the bi-stable function, the power consumption only generates between the OFF and ON state, resulting in zero static power consumption. The switch was fabricated by silicon-on-glass (SOG) processes with only two lithographic masks. Measured results have shown that the manufactured RF MEMS switch successfully realized the bi-stable function at an operating voltage of 38 V. At 6 GHz, the measured isolation was − 33.18 dB, while the insertion loss was below − 1.9 dB. The presented switch in this paper is dedicated for low power consumption and low hardware redundancy wireless communication systems.

Electro-thermally actuated RF MEMS switch for wireless communication.

A Low-Voltage Lateral MEMS Switch with High RF Performance

An Ultra-Broadband Contact-Capacitive RF MEMS Switch for 15-110GHZ Applications

Design and simulation of a novel electro-thermally actuated lateral RF MEMS latching switch for low power applications

Novel Multicontact Radio Frequency Microelectromechanical System Switch in High-Power–handling Applications

Intermodulation Distortion in MEMS Capacitive Switches under High RF Power

Design and fabrication of X-band capacitive MEMS switches

SP4T RF MEMS Switch with Low Actuation Voltage

Design and Fabrication of a Low Insertion Loss Capacitive RF MEMS Switch with Novel Micro-Structures for Actuation

A dielectric-bridge-type MEMS series contact switch for 0-10GHz applications

Design and Analysis of a Lateral Lateral DC-Contact MEMS RF Switch with High Performance

Power Handling Capability Enhanced RF MEMS Switch Using Modified-Width Cantilevers Structure

Scalable Contact-Capacitive MEMS Switches with High Capacitance Ratio for Millimeter-Wave Applications

Rf Mems Switch and Its Applications

DC-contact Series Radio-Frequency Micro Electromechanical System Switch with Slanting Beams

Implementation of Highly Reliable Contacts for RF MEMS Switches

Design and Fabrication of a Capacitive Series RF MEMS Switch

A Novel 3-resonance Capacitive RF MEMS Switch

DISTRIBUTED MULTICONTACT RF MEMS SWITCH FOR POWER HANDLING CAPABILITY IMPROVEMENT

Design of Broadband High-Frequency Multi-Throw RF-MEMS Switches

A Zero Static Power Consumption Bi-Stable RF MEMS Switch Based on Inertial Generated Timing Sequence Method