Abstract:In order to improve the mechanical reliability and lifetime of a series contact Radio Frequency Microelectro-mechanical System(RF MEMS) switch with dielectric bridge,the fabrication process was studied.The switch structure was analyzed,the results illustrated that the mechanical reliability of the switch was debased with regular process because of the stress concentration of the bridge film.After that,an isotropic undercutting process for forming the upper control electrodes and contact bar under the bridge was proposed to obtain plane bridge film.Finally,the whole process of the switch was presented.Compared with the regular process,the proposed method can avoid the problem of stress concentration,and can improve the mechanical reliability of the switch.As a result,the yield rate of the switch increases from 10% up to 95%,the lifetime is improved from 1 000 cycles up to 2.5×107 cycles.In addition,under the actuation voltage of 23.3 V,the insertion loss is less than 0.55 dB@DC-10 GHz,and the isolation is more than 53.2 dB@DC-10 GHz.These results show that proposed process can satisfy the modern wireless communication system requirements of yield rate,lifetime and microwave performance.

DISTRIBUTED MULTICONTACT RF MEMS SWITCH FOR POWER HANDLING CAPABILITY IMPROVEMENT

Power Handling Capability Enhanced RF MEMS Switch Using Modified-Width Cantilevers Structure

Novel Multicontact Radio Frequency Microelectromechanical System Switch in High-Power–handling Applications

Power Handling Capability Improvement of Metal-Contact RF MEMS Switches by Optimized Array Configuration Design of Contact Dimples

Intermodulation Distortion in MEMS Capacitive Switches under High RF Power

Multi-contact Radiofrequency Microelectromechanical Systems Switch with Power Divider/combiner Structure for High Power Applications

Study on RF MEMS Switch with Four Parallel Ohm Contacts for Power Handling Enhancement

A Low-Supply-voltage High-Power-handling Stacked SPDT Switch Based on Feedforward Capacitors.

Design and Analysis of a Lateral Lateral DC-Contact MEMS RF Switch with High Performance

Scalable Contact-Capacitive MEMS Switches with High Capacitance Ratio for Millimeter-Wave Applications

An Ultra-Broadband Contact-Capacitive RF MEMS Switch for 15-110GHZ Applications

A Packaged 2×2 Switch Array for Power Handling and Isolation Improvement

Electro-thermally actuated RF MEMS switch for wireless communication.

Implementation of Highly Reliable Contacts for RF MEMS Switches

Preparing of a High Speed Bistable Electromagnetic RF MEMS Switch

Novel Process for Fabrication of RF MEMS Switch with High Mechanical Reliability

Design and Simulation of a Novel RF MEMS SP2T Switch

A High-Linearity SP12T RF MEMS Switch Using Parallel Dual-Cantilevers for 5G and Beyond Applications

Design and Simulation of RF MEMS Switch

Improving Performance of the Metal-to-metal Contact RF MEMS Switch with a Pt–Au Microspring Contact Design

Design and fabrication of X-band capacitive MEMS switches