Abstract:A new isolation optimization method of radio frequency (RF) microelectromechanical systems (MEMS) capacitive switches is carried out in this paper. We simplified the coplanar waveguide and the top movable electrode as two-port network. The existence of the maximum isolation of single switch is proved theoretically based on circuit model and S-parameters model. The isolation of the distributed switches with lossless transfer lines, which is the function of the transfer lines length and the impedance of metal beams, is described by mathematic expressions and simulated in a numerical method. We find that the isolation varies periodically with theta and f, which are the electrical length between metal beams of the distributed switches and the signal frequency. It achieves the maximum value 83dB at theta= pi/2 for 2-beams switch. However, different from single beam switches, the distributed switches maximum isolation is near but not precisely at the resonance frequency f(0). The bandwidth of RF signal can be widened to about 200% for 5-beams switch by using the proposed design method. The results will be useful for Resistance-Inductance-Capacitance parameters optimization of RF MEMS Capacitive switches.

New isolation optimization method of RF MEMS capacitive switches

Design, optimization and simulation of a low-voltage shunt capacitive RF-MEMS switch

Design and Fabrication of a Capacitive Series RF MEMS Switch

Design and fabrication of X-band capacitive MEMS switches

Intermodulation Distortion in MEMS Capacitive Switches under High RF Power

Scalable Contact-Capacitive MEMS Switches with High Capacitance Ratio for Millimeter-Wave Applications

Design and simulation of a novel RF MEMS shunt capacitive switch with low actuation voltage and high isolation

A Novel 3-resonance Capacitive RF MEMS Switch

An Improved Design Method Based on a Multi-Plate Coupler Structure for Capacitive Power Transfer with Wide Ranges of Misalignment and Loads

Capacitive Rf MEMS Switch with Composite Beam

A High Isolation Series-Shunt Rf Mems Switch

A CMOS SPDT RF Switch with 68 Db Isolation and 1.0 Db Loss Feathering Switched Resonance Network for MIMO Applications

DISTRIBUTED MULTICONTACT RF MEMS SWITCH FOR POWER HANDLING CAPABILITY IMPROVEMENT

Design and Fabrication of a Low Insertion Loss Capacitive RF MEMS Switch with Novel Micro-Structures for Actuation

Modeling and Analysis of DC-contact RF MEMS Switch Considering Crosstalk Between DC and RF Signals

Power Handling Capability Enhanced RF MEMS Switch Using Modified-Width Cantilevers Structure

High-isolation lateral RF MEMS capacitive switch based on HfO2 dielectric for high frequency applications

Design and Analysis of A Micromachined Capacitive Rf Shunt Switch with Composite Membrane

An Ultra-Broadband Contact-Capacitive RF MEMS Switch for 15-110GHZ Applications

An Analytical Model for High Performance Capacitive RF MEMS Switch Design

Study on RF MEMS Switch with Four Parallel Ohm Contacts for Power Handling Enhancement