Abstract:In order to improve the mechanical reliability and lifetime of a series contact Radio Frequency Microelectro-mechanical System(RF MEMS) switch with dielectric bridge,the fabrication process was studied.The switch structure was analyzed,the results illustrated that the mechanical reliability of the switch was debased with regular process because of the stress concentration of the bridge film.After that,an isotropic undercutting process for forming the upper control electrodes and contact bar under the bridge was proposed to obtain plane bridge film.Finally,the whole process of the switch was presented.Compared with the regular process,the proposed method can avoid the problem of stress concentration,and can improve the mechanical reliability of the switch.As a result,the yield rate of the switch increases from 10% up to 95%,the lifetime is improved from 1 000 cycles up to 2.5×107 cycles.In addition,under the actuation voltage of 23.3 V,the insertion loss is less than 0.55 dB@DC-10 GHz,and the isolation is more than 53.2 dB@DC-10 GHz.These results show that proposed process can satisfy the modern wireless communication system requirements of yield rate,lifetime and microwave performance.

Al/Au Composite Membrane Bridge DC-contact Series RF MEMS Switch

DC-contact Series Radio-Frequency Micro Electromechanical System Switch with Slanting Beams

Design and Fabrication of DC to 30 GHz DC-contact Shunt RF MEMS Switch

Capacitive Rf MEMS Switch with Composite Beam

A dielectric-bridge-type MEMS series contact switch for 0-10GHz applications

Design and Analysis of a Lateral Lateral DC-Contact MEMS RF Switch with High Performance

Realization of A Series Contact Mems Switch with Sion Dielectric Bridge

Copper-Based Multimetal-Contact Rf Mems Switch

Improving Performance of the Metal-to-metal Contact RF MEMS Switch with a Pt–Au Microspring Contact Design

Novel Process for Fabrication of RF MEMS Switch with High Mechanical Reliability

Design and Fabrication of a Capacitive Series RF MEMS Switch

Multi-contact Radiofrequency Microelectromechanical Systems Switch with Power Divider/combiner Structure for High Power Applications

A low-loss RF MEMS switch with dielectric layer on the lower surface of the bridge

Preparing of a High Speed Bistable Electromagnetic RF MEMS Switch

Design and fabrication of X-band capacitive MEMS switches

Novel Multicontact Radio Frequency Microelectromechanical System Switch in High-Power–handling Applications

Design and Fabrication of a Low Insertion Loss Capacitive RF MEMS Switch with Novel Micro-Structures for Actuation

SP4T RF MEMS Switch with Low Actuation Voltage

Electro-thermally actuated RF MEMS switch for wireless communication.

High-Isolation Contact Switch in Mems Phase Shifter

A High-Linearity SP12T RF MEMS Switch Using Parallel Dual-Cantilevers for 5G and Beyond Applications