Abstract:Replacement of Co by alternative Ni binder in gradient cemented carbide is an effective way to reduce the health concerns associated with Co powders. In the present work, gradient cemented carbides with different Ni contents and gradient sintering times were prepared by traditional powder metallurgy with a two-step sintering method. The microstructure of cemented carbide including the gradient layer formation was analyzed by XRD, SEM, EDS, TEM, and EBSD. The thickness of the gradient layer is almost proportional to the square root of sintering time, indicating that the gradient layer formation is a diffusion-controlled process. The atomic migration can be accelerated to form a thicker gradient layer with the increase of the binder content. The coherent interface of the Ti(C, N) core-rim structure for the gradient cemented carbides with Ni binder was revealed. With the increase in binder content, the average grain size of the WC phase is increased. The hardness and fracture toughness of the cemented carbides were also studied and analyzed according to the crack propagation behavior and the distribution of dislocation and stress indicated by KAM and GND. The variation of the hardness and the fracture toughness with the sintering time is mainly related to the density and the grain size of hard phases, while the change of the mechanical properties along with the Ni content probably results from the local dislocation density and the stress in the cemented carbides. The cemented carbide can obtain a good combination of hardness and fracture toughness with 10 wt% Ni gradient sintered for 2h.

TiC-Ni functionally gradient material produced by SHS

COMBUSTION SYNTHESIS AND THERMAL STRESS ANALYSIS OF TIC-NI FGM

Research on TiC-Ni cermets by SHS and pseudo heat isostatic pressing

Rapid Prototyping and Combustion Synthesis of TiC/Ni Functionally Gradient Materials

Microstructure and mechanical properties of TiC-Ni functionally graded materials by simultaneous combustion synthesis and compaction

INFLUENCE OF Ni CONTENT ON TiC-Ni CERMETS BY SHS/PHIP

Dense TiC-Al2O3 composites fabricated by SHS

MECHANICAL PROPERTIES OF TiC-Ni PRODUCED BY SHS AT ROOM AND HIGH TEMPERATURES

Effect of TiC Content on Mechanical Properties and Microstructure Evolution of TiC/Inconel 718 Functionally Gradient Materials by Direct Energy Deposition

FABRICATION AND CHARACTERIZATION OF FUNCTIONALLY GRADED Ni–Ti MULTILAYER THIN FILMS

Investigation of TiC formation during ball-milling of elemental titanium and carbon

In situ formation by laser cladding of a TiC composite coating with a gradient distribution

Fabrication of gradient WC-Ni cemented carbide materials by high gravity-assisted combustion synthesis and infiltration

Microstructure and resisting thermal shock behaviors of TiC-Al2O3/Fe functionally graded materials prepared by SHS/PHIP

Mechanical Properties and Optimal Grain Size Distribution Profile of Gradient Grained Nickel

Structural characterization and reaction mechanism of the Ti/SiC gradient material with Mg 2 Si additive fabricated by reaction sintering

Microstructure and mechanical properties of TC4/NiTi bionic gradient heterogeneous alloy prepared by multi-wire arc additive manufacturing

Microstructure and Properties of TiN-reinforced W–Ti Alloys Prepared by Spark Plasma Sintering

Effect of binder content and sintering time on the microstructure and mechanical properties of gradient cemented carbides with Ni binder

A study on the possibility to process dense 60NiTi from elementally blended Ni and Ti powders

Reaction-induced nano-sized TiC in additive manufactured Ni-Co based superalloy