Abstract:Functional gradient materials (FGMs) have garnered increasing interest for their potential in material and structural design. Additive manufacturing, as a kind of free manufacturing and near-net shaping technology with in-situ controllability of materials, is the dominant technology for fabricating FGMs. While numerous studies have been conducted on titanium alloy FGMs, there is still a lack of research on the structure and properties of the material with the number of transitional layers. This study employs double-wire arc additive manufacturing to fabricate FGMs composed of TC4 and TC11 alloys. The study examines the utilization of direct and continuous transition forms in conjunction with stress relieving and solution aging heat treatment processes. The composition, grain morphology, microstructure, and mechanical properties of FGMs are analyzed. Results indicate that in samples employing direct transition, higher heat treatment temperatures and durations lead to a more uniform composition and microstructure. Additionally, the interface morphology becomes increasingly indistinct, and transversal elongation at the interface is enhanced by the strain compensation of the two materials. In continuous transitional samples, an increase in the number of transitional layers results in a more uniform microstructure near the interface, leading to a reduction in interface morphology and an enhancement of mechanical properties. The fracture position tends to shift closer to the TC4 side, with both process forms exhibiting ductile fractures. The plasticity of the TC4 part is superior, and the ductile fracture morphology is more pronounced. This study offers a valuable experimental foundation for investigating the direct and continuous transition of titanium alloy FGMs.

COMBUSTION SYNTHESIS AND THERMAL STRESS ANALYSIS OF TIC-NI FGM

Microstructure and mechanical properties of TiC-Ni functionally graded materials by simultaneous combustion synthesis and compaction

Rapid Prototyping and Combustion Synthesis of TiC/Ni Functionally Gradient Materials

Combustion synthesis TiC-Al2O3/Fe FGM and its resisting thermal shock behaviors

Combustion Synthesis TiC-A12O3/Fe FGM and its Resisting Thermal Shock Behaviors

Microstructure and resisting thermal shock behaviors of TiC-Al2O3/Fe functionally graded materials prepared by SHS/PHIP

TiC-Ni functionally gradient material produced by SHS

ELASTOPLASTIC OPTIMUM DESIGN OF Ni/TiC FUNCTIONAL GRADIENT MATERIAL

Thermal Shock Behavior of a Novel TiCx–Ni3(Al,Ti)/Ni Functionally Graded Composite

Thermal stress simulation in TiB2-Cu functionally graded materials

Research on TiC-Ni-Mo Composites by Combustion Synthesis

Research on TiC-Ni cermets by SHS and pseudo heat isostatic pressing

MECHANICAL PROPERTIES OF TiC-Ni PRODUCED BY SHS AT ROOM AND HIGH TEMPERATURES

Fabrication and properties of TiC/Ti3SiC2 composites and FGMs

Fabrication and Properties of TiC/Ti<sub>3</sub>SiC<sub>2</sub> Composites and FGMs

Research on the microstructure and mechanical properties of functional gradient materials of TC4/TC11 titanium alloys for wire arc additive manufacturing with different transitional forms

Experimental Analysis for Thermal Stress in Functionally Gradient Material

Fabrication and wear behavior of TiC/TiB 2 -reinforced NiAl intermetallic matrix composites

Analysis of Mechanical-Thermal Coupled Experiments of Single Crystal TiNi Alloys

Fabrication Of Sic/Cu Functionally Gradient Material By Graded Sintering