Abstract:Electrochemical etching of silicon carbide (SiC) material has received increasing attention in recent years, due to its simple procedure, low cost and significance in the exploration of novel optoelectronic devices. In this paper, 4H-SiC substrates were electrochemically etched at a constant current density of 392.98 mA cm-2 in an electrolyte made up of hydrofluoric acid and deionized water. The layering of a SiC porous layer and periodic fluctuation of the voltage were witnessed for the first time, with the layering phenomenon corresponding well to the voltage period. However, no such phenomenon was observed when the SiC substrates were anodic etched under the same conditions with magnet stirring. As a result, the periodic variation of voltage was hypothesized to be the cause of regular layering during constant current electrochemical etching. Electrochemical etching in potentiostatic mode was thus performed at different voltages. We found that the diameter of the SiC nanopores increased while the thickness of the sidewall decreased with the increasing voltage. Based on the experimental findings, a model of mass transport was proposed. The mass transport process leads to periodic changes in resistance, hence the periodic change in voltage. This successfully explained the reason for the layering. Furthermore, SiC substrates were also electrochemically etched at high and low current densities, finding the existence of a threshold current density for the occurrence of the layering. Energy dispersive x-ray spectroscopy analysis showed that the composition of the SiC porous layer remained unchanged compared to the pure SiC wafer, implying that the peeling-off of the SiC porous layer obtained by electrochemical etching can be directly adopted for use on devices requiring a SiC porous structure.

Current automatic control technology for n-type macroporous silicon photo-electrochemical etching

Photo-electrochemical Etching of Macroporous Silicon Arrays Used in Silicon Microchannel Plates

Research on Integrated Trench Etching for Trench-Type Power MOSFET

Optimization of anodic current density for growth of thick p-type macropore porous silicon

Pore size modulation in electrochemically etched macroporous p-type silicon monitored by FFT impedance spectroscopy and Raman scattering.

High Anodic-Voltage Focusing of Charge Carriers in Silicon Enables the Etching of Regularly-Arranged Submicrometer Pores at High Density and High Aspect-Ratio

Influence Of Anodization Current Density On Preparation And Corrosion Of N-Type Macroporous Silicon In 1.0 M Naoh

Ultrafast fabrication of high-aspect-ratio macropores in P-type silicon: toward the mass production of microdevices

Fabrication of Ordered Macropore Arrays in n-Type Silicon Wafer by Anodic Etching Using Double-Tank Electrochemical Cell

Systematic Study on Pulse Parameters in Fabricating Porous Silicon-Layered Structures by Pulse Electrochemical Etching

Self-organized pore formation and open-loop-control in semiconductor etching

A Study of Selectively Digital Etching Silicon-Germanium with Nitric and Hydrofluoric Acids

Study of the Nanometer Scale Polysilicon Micro Structure Etching

Black Silicon with Controllable Macropore Array for Enhanced Photoelectrochemical Performance

Uniform Vertical Trench Etching on Silicon with High Aspect Ratio by Metal-Assisted Chemical Etching Using Nanoporous Catalysts.

Study on the layering phenomenon of SiC porous layer fabricated by constant current electrochemical etching

Chemical Etching Processes at the Dynamic GaAs/Electrolyte Interface in the Electrochemical Direct-Writing Micromachining

High Aspect Ratio Etching of Nanopores in PECVD SiC Through AAO Mask

Study on the Distribution Control of Etching Rate and Critical Dimensions in Microwave Electron Cyclotron Resonance Plasmas for the Next Generation 450 mm Wafer Processing

Wet Etch Rate Behavior of Poly-Si in TMAH Solution at Various Ambient Gas Conditions

High Aspect Ratio Si Etching Technique and Application