Abstract:With the development of analytical instrumentation to minimization,integration and automation,the microfluidic chips,which are more integrated,complex and diversified,have been applied widely on the manufacturing of analytical instrumentation.However,the present photolithography-based microfabrication technology,which is only able to pattern microchannels with simple inside structures,can not follow the rapid development of requirements.For solving the problem,a fabrication method based on the restricting effect of laminar flow is proposed for the micro etching on isotropic substrates.Experiments were conducted inside glass-based microchannels,in which certain etchant was used to form complicated microstructures.The flow parameters’ effects on the aspect ratio,side wall profile and etching rate were revealed by the experiments.The experimental results reveal that the topography of micro structures patterned with the restricted flow etching method is mainly determined by the flowrates of separator and etchant.The computational fluid dynamics（CFD） model on the interface between multiple streams was established for the etching process,and analysis on the causes of various micro topographies was conducted based on the CFD simulation results.The experimental data consisted with the simulation results very well.The investigation depicted in this paper indicate that the flow restricted etching method provides sufficient references for the research and understanding on the mass transport at the liquid-liquid surface in the microchannel and can be used to pattern complex micro structures with high aspect ratios,meantime,it greatly enriches the microfabrication technology for microfluidic chips.

Wafer-scale Fabrication of High-Aspect Ratio Nanochannels Based on Edge-Lithography Technique.

Simple and Cost-Effective Fabrication of Two-Dimensional Plastic Nanochannels from Silica Nanowire Templates

A facile nanowire fabrication approach based on edge lithography

Fabrication of High Aspect Ratio Nano-Channels by Thermal Nano-Imprinting and Parylene Deposition

Design and fabrication of a nanofluidic channel by selective thermal oxidation and etching back of silicon dioxide made on a silicon substrate

Fabrication of full glass chips with hybrid micro- and nanochannels and their application to protein concentration

Wafer-Scale Fabrication of V-Shaped Silicon Nano-Slit Arrays

Fabrication of 1D nanofluidic channels on glass substrate by wet etching and room-temperature bonding

Preparation of Rhombus-Shaped Micro/nanofluidic Channels with Dimensions Ranging from Hundred Nanometers to Several Micrometers.

Fabrication of sub-50 nm nanochannel array by an angle forming lift-off method

Fabrication of 2D silicon nano-mold by side etch lift-off method

Fabrication of ultrahigh-aspect-ratio and periodic silicon nanopillar arrays using dislocation lithography and deep reactive-ion etching

Micro Etching Method Inside Microchannels

Integrated fabrication of micro/nano-fluidic chip based on nano-imprint lithography and bonding

Fabrication of Optofluidic Systems Using Isotropic Wet Etched Masters in < 111 > Silicon Wafer

Flow-restricted Etching Method on Isotropic Substrates and Its Mechanism

High Aspect Ratio Etching of Nanopores in PECVD SiC Through AAO Mask

Massively-parallel Ultra-High-aspect-ratio Nanochannels As Mesoporous Membranes.

Fabrication And Characterization Of Sub-100/10nm Planar Nanofluidic Channels By Triple Thermal Oxidation And Silicon-Glass Anodic Bonding

Massive Fabrication of Silicon Nanopore Arrays with Tunable Shapes

Fabrication of Silicon Nanopore Arrays Using A Combination of Dry and Wet Etching