Abstract:Metal assisted chemical etching (MACE), as an emerging wet chemical etching method for fabricating semiconductor micro/nano-structures (MNS), has attracted wide attentions because of the advantages of simple processes, high accuracy and no damages. However, the conventionally used noble metal catalysts (such as Au, Pt,) trapped in the micro/nano-structures are difficult to be removed or reused, not only harming the electronic performances of the CMOS devices but also increasing the fabrication cost. Here, we propose an electrochemical nanoimprint strategy by using a glassy carbon (GC) imprint mold. To overcome the poor electrocatalytic activity of GC, the GC imprint mold was connected to a Pt sheet in the cathodic chamber. To avoid the contaminations of metal and metallic cations in the fabricated MNS, the cathodic chamber was separated from the anodic one by a proton exchange membrane. By optimizing the technical parameters, including the contact pressure between GC imprint mold and GaAs wafer, the concentration of electron acceptor in the cathodic chamber, the imprinting time, etc., a remarkable corrosion rate of about 130 nm/min was achieved, comparable with that of platinum electrocatalyst. Furthermore, by using a GC imprint mold in the spatially separated corrosion cell, the contaminations caused by both the metal catalysts and metallic ions can be eliminated. Thus, this work provides a potential approach to the high throughput fabrication of CMOS-compatible semiconductor microdevices.

Fabrication of 2D silicon nano-mold by side etch lift-off method

Fabrication of sub-50 nm nanochannel array by an angle forming lift-off method

Fabrication of Large-Area Nanostructures Using Cross-Nanoimprint Strategy

A Low-Cost and High-Efficiency Method for Four-Inch Silicon Nano-Mold by Proximity UV Exposure

Fabrication of Nanoimprint Mold by Multilayer Film Deposition Technique

Scanning probe lithography for nanoimprinting mould fabrication

Large Area Mold Fabrication for the Nanoimprint Lithography Using Electron Beam Lithography

Route to Cost-Effective Fabrication of Wafer-Scale Nanostructure Through Self-Priming Nanoimprint

A Low-Cost Method of Fabricating Hybrid Micro-Nano Fluidic Chip by Double-Layer PDMS Mold and UV–thermal Nanoimprinting

Bi-Layer Nanoimprinting Lithography for Metal-Assisted Chemical Etching with Application on Silicon Mold Replication

Integrated fabrication of micro/nano-fluidic chip based on nano-imprint lithography and bonding

A Low-Cost Fabrication Method for High Aspect Ratio Nano-Channels by Near-Field UV Exposure and Thermal Nanoimprinting

Innovative Two-Step Method for Efficient Silicon Microfluidic Device Fabrication: Integrating Laser Ablation with Wet Etching

CMOS-compatible Electrochemical Nanoimprint: High Throughput Fabrication of Ordered Microstructures on Semiconductor Wafer by Using a Glassy Carbon Mold

CMOS-Compatible Electrochemical Nanoimprint:High Throughput Fabrication of Ordered Microstructures on Semiconductor Wafer by Using a Glassy Carbon Mold

Ultrahigh Precision Low-Cost Pinpointed SiO2 Patterns Nanofabrication by Using Traditional MEMS Fabrication Processes

Nanoimprint lithography technology

Fabricating 3D Si nanostructure via a novel Ga+ implantation enabled maskless dry etching process

Electrically Driven Nano-molding Technique Based on Electrohydrodynamics

Fabrication of Ultraviolet-Nanoimprint Mold of 2-Dimensional Sub-Wavelength Structured Surface on Quartz Substrate

Fabrication of large-scale periodic silicon nanopillar arrays for 2D nanomold using modified nanosphere lithography☆