Abstract:With the development of analytical instrumentation to minimization,integration and automation,the microfluidic chips,which are more integrated,complex and diversified,have been applied widely on the manufacturing of analytical instrumentation.However,the present photolithography-based microfabrication technology,which is only able to pattern microchannels with simple inside structures,can not follow the rapid development of requirements.For solving the problem,a fabrication method based on the restricting effect of laminar flow is proposed for the micro etching on isotropic substrates.Experiments were conducted inside glass-based microchannels,in which certain etchant was used to form complicated microstructures.The flow parameters’ effects on the aspect ratio,side wall profile and etching rate were revealed by the experiments.The experimental results reveal that the topography of micro structures patterned with the restricted flow etching method is mainly determined by the flowrates of separator and etchant.The computational fluid dynamics（CFD） model on the interface between multiple streams was established for the etching process,and analysis on the causes of various micro topographies was conducted based on the CFD simulation results.The experimental data consisted with the simulation results very well.The investigation depicted in this paper indicate that the flow restricted etching method provides sufficient references for the research and understanding on the mass transport at the liquid-liquid surface in the microchannel and can be used to pattern complex micro structures with high aspect ratios,meantime,it greatly enriches the microfabrication technology for microfluidic chips.

Design and fabrication of a nanofluidic channel by selective thermal oxidation and etching back of silicon dioxide made on a silicon substrate

Simple and Cost-Effective Fabrication of Two-Dimensional Plastic Nanochannels from Silica Nanowire Templates

Fabrication And Characterization Of Sub-100/10nm Planar Nanofluidic Channels By Triple Thermal Oxidation And Silicon-Glass Anodic Bonding

A Simple Technique for Sub-10 Nm Planar Nanofluidic Channel Fabrication

Fabrication of Sub-10 Nm Planar Nanofluidic Channels Through Native Oxide Etch and Anodic Wafer Bonding

Micro Etching Method Inside Microchannels

Fast and Maskless Nanofabrication for High-Quality Nanochannels

Fabrication of fluidic submicron-channels by pulsed laser-induced buckling of SiOx films on fused silica

Fabrication of Size-Controllable Nanofluidic Channels Using Angled Physical Vapor Deposition

Fabrication of Optofluidic Systems Using Isotropic Wet Etched Masters in < 111 > Silicon Wafer

Preparation of Silicon Oxide Nanofluids Via Microfluidic for Enhanced Flow Boiling Heat Transfer

Selective etching of n-type silicon in pn junction structure in hydrofluoric acid and its application in silicon nanowire fabrication.

Oxidation of High Area Ratio Silicon Microchannels Fabricated by Electrochemical Etching

Flow-restricted Etching Method on Isotropic Substrates and Its Mechanism

Innovative Two-Step Method for Efficient Silicon Microfluidic Device Fabrication: Integrating Laser Ablation with Wet Etching

Fabrication of Enclosed Nanofluidic Channels by UV Cured Imprinting and Optimized Thermal Bonding of SU-8 Photoresist

Fabrication of Nanochannels with Water-Dissolvable Nanowires

Fabrication of Silicon Nano-Wire by Oxidation

Wafer-scale Fabrication of High-Aspect Ratio Nanochannels Based on Edge-Lithography Technique.

Preparation of Rhombus-Shaped Micro/nanofluidic Channels with Dimensions Ranging from Hundred Nanometers to Several Micrometers.

A Simple Approach for an Optically Transparent Nanochannel Device Prototype