Abstract:Channel fabrication technology has become increasingly important for microfluidic and nanofluidic devices. In particular, glass channels have high chemical and physical stability, high optical transparency, and ease of surface modification, so that there is increasing interest in glass microfluidic devices for chemical experiments in microfluidics and nanofluidics. For the fabrication of glass channels, especially those with a high aspect ratio (depth/width), lithography using a metal resist and dry etching have mainly been used. However, there are still issues involving the surface roughness of the etched channel and the low etching selectivity. In this study, a microchannel fabrication method with high etching selectivity that produces a smooth etched surface was developed. First, interference during dry etching by remaining Cr particles after the photolithography and Cr etching processes was assumed as the cause of the rough etched surface. Three different dry etching processes were introduced to verify this. In process 1 without removal of the Cr particles, the etched surface was not flat and had a 1 μm scale roughness. In process 2 where a cleaning process was included and high power etching was conducted, a smooth surface with a 1 nm scale roughness and a faster etching rate of 0.3 μm/min were obtained. For this high-power etching condition, the etching selectivity (fused silica/Cr) was relatively low at approximately 39-43. In process 3 with a cleaning process and low-power etching, although the etching rate was relatively low at 0.1 μm/min, a smooth surface with 1 nm scale roughness (10 nm scale roughness deeper than 40 μm in the depth region) and a much higher etching selectivity of approximately 79-84 were obtained. The dry etching method presented in this study represents a significant contribution to microfluidics/nanofluidics for microchannel/nanochannel fabrication.

Micro Etching Method Inside Microchannels

Flow-restricted Etching Method on Isotropic Substrates and Its Mechanism

Study On Characteristics Of Interface Between Multiple Laminar Streams And Application For Secondary Etching Inside Microchannels

A Novel Restricted-Flow Etching Method for Glass

Micro Fabrication of Micro Fluidic Glass Chip Without Clean Room Condition

Design and fabrication of a nanofluidic channel by selective thermal oxidation and etching back of silicon dioxide made on a silicon substrate

Fabrication of full glass chips with hybrid micro- and nanochannels and their application to protein concentration

SIMULATION AND MICRO-PIV RESEARCH ON CLASSICAL MICROCHANNEL FLOW

Fabrication of Micro/Nanofluidic Chip on Glass Substrate and Its Application for Electrokinetic Concentration of Proteins

Fabrication of Fluidic Chips with 1-D Nanochannels on PMMA Substrates by Photoresist-Free UV-lithography and UV-assisted Low-Temperature Bonding

Fabrication of 1-d nanochannels on PMMA substrate by photoresist-free uv lithography and UV-assisted bonding under low temperature

Novel polydimethylsiloxane (PDMS) based microchannel fabrication method for lab-on-a-chip application

Fabrication of microchannels by space-selective control of phase separation in glass.

A Simplified Microfabrication Technology For Production Of Glass Microfluidic Chips

Preparation of Rhombus-Shaped Micro/nanofluidic Channels with Dimensions Ranging from Hundred Nanometers to Several Micrometers.

Fused silica microchannel fabrication with smooth surface and high etching selectivity

An Alternative Micro-Milling Fabrication Process for Rapid and Low-Cost Microfluidics

Integrated fabrication of micro/nano-fluidic chip based on nano-imprint lithography and bonding

Glass etching to bridge micro- and nanofluidics.

Preparation of microfluidic chips by electroplating and used for microdroplet study

A Rapid and Low-Cost Procedure for Fabrication of Glass Microfluidic Devices